Overview
The Dana Spicer 10043169 is a rear right axle shaft for the Dana 44 AdvanTEK rear axle. It has 32 splines and is made from SAE-4340 nickel chromoly steel. It fits the 2018–2026 Jeep Wrangler (JL) and the 2020–2026 Jeep Gladiator.
Dana Spicer says its chromoly shafts are built for the demands of off-road use. The nickel chromoly steel gives additional toughness, high-temperature strength and abrasion resistance, and it keeps a specified hardenability. The shaft is sold for the rear passenger side only.
Key features
- SAE-4340 nickel chromoly steel for toughness and high-temperature strength
- Abrasion resistance and maintained hardenability
- 32 splines
- Rear right, passenger side position
- Designed for the Dana 44 AdvanTEK axle
Driveline wear signs
An axle shaft works under torque, and its splines and bearings take a lot of load on rough trails. Chromoly steel helps resist fatigue and wear, but the shaft still needs regular inspection. The shaft connects the axle to the wheel, so any problem there shows up quickly as vibration or noise.
When the old shaft comes out, check the splines for twisting, pitting or rounded edges and look at the axle seal for leaks. Oil at the seal can reach the bearing and cause early failure, so replace a leaking seal while the shaft is off. Clean the spline surfaces and apply the lubricant the axle calls for before reassembly.
- Clicking or popping on sharp turns
- Vibration that rises with speed
- Grease or oil on the inside of the wheel
- Splines that look rounded or twisted
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10043169 |
| Axle | Dana 44 AdvanTEK, rear |
| Axle shaft location | Passenger side |
| Position | Rear right |
| Spline count | 32 |
| Material | SAE-4340 nickel chromoly |
Vehicle fitment
It fits the 2020–2026 Jeep Gladiator and the 2018–2026 Jeep Wrangler (JL), in two-door and four-door models including the Unlimited. Earlier Wrangler generations such as the JK do not fit. Check your year, model and trim before ordering.
Only the JL and Gladiator are listed. Check the rear axle type and the side before ordering.
Installation notes
Confirm the shaft is for the rear right position on a Dana 44 AdvanTEK before fitting. It is for the passenger side only, so a driver side shaft is a separate part.
What’s included
One rear right axle shaft assembly.








