Overview
The Dana Spicer 660182-10 is a passenger side front inner axle shaft for Dana 60 front axles, with 35 splines. It is an O.E. replacement design, matching the original factory layout.
The inner shaft runs from the differential to the passenger side front wheel. Confirm the side and spline count of your current shaft before ordering.
Key features
- Passenger side inner position
- 35 spline count
- O.E. replacement design.
- Dana 60 front axle type
Inner shafts and axle wear
Inner axle shafts carry torque from the differential out toward the wheel, and they take a steady beating from engine power and rough ground. Over time the splines at the differential end can wear, and the boot or seal near the joint can dry out. Either problem tends to show up as vibration, clunking when power comes on, or grease on the inside of the wheel.
When replacing one, check the axle flange, the differential side seal and the axle bearing for play before the new shaft goes in. Use the same spline count and side as the old part, and keep the mating surfaces clean so the shaft seats fully. After installation, check for leaks and listen for any new noise during the first few drives.
- Check spline wear at the differential end
- Inspect the joint boot or seal
- Match side and spline count before fitting
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 660182-10 |
| Axle type | Dana 60 |
| Axle location | Front |
| Shaft location | Passenger side inner |
| Axle spline | 35 splines |
| Popular axle manufacturer | Dana |
Vehicle fitment
Fitment can be confirmed only by matching the vehicle’s Dana 60 front axle to this shaft’s side and spline count.
Axle type and spline count alone do not identify a vehicle. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item is the passenger side inner shaft only. Check hardware, seals and bearings against your installation before starting.





