Overview
The Dana Spicer Dana 35 rear axle shaft, part number 73624-1X, is a replacement passenger side shaft for Dana 35 rear axles. It is for 1990-2000 Jeep YJ, XJ and TJ models without ABS.
Dana Spicer describes its replacement shafts for popular applications that do not need upgraded shafts, or for replacing damaged or broken ones. This shaft has a 29.04in overall length, 27 splines and a 5 on 4.5in bolt pattern.
Key features
- Passenger side shaft
- 27 spline, 1.18in
- 5 on 4.5in bolt pattern
- C-clip style retention
Before you swap a shaft
A C-clip axle shaft is held in place by a clip at the inner end, which sits inside the axle tube behind the bearing. Removing it usually means lifting the axle flange off the studs, pulling the shaft out and checking the bearing and retainer. Because the clip and bearing work as a set, a shaft that drops in easily may still need the retainer and bearing inspected before reuse.
Worn splines or a loose flange are common reasons to swap a shaft. Inspect the spline ends for twisting or rounding, and feel for play at the flange. Keep the brake drum and hub clean during the job, and make sure the driver side shaft is in good condition as well, since both sides carry load together.
- Inspect the spline ends for wear
- Check the bearing and retainer
- Keep the brake components clean
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 73624-1X |
| UPC | 23913133702 |
| Axle location | Rear |
| Axle type | Dana 35 |
| Shaft location | Passenger side |
| Overall length | 29.04in |
| Spline | 1.18in, 27 spline |
| Bolt pattern | 5 on 4.5in |
| Retention | C-clip style |
Vehicle fitment
It fits Wrangler YJ from 1990 to 1995, Cherokee XJ from 1990 to 2000, and Wrangler TJ from 1997 to 2000, on models without ABS.
Wrangler YJ years before 1990, Wrangler TJ years after 2000, and Wrangler JK models fall outside the stated years. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This is a passenger side shaft, so the driver side needs its own shaft. Because it is C-clip style, the retaining clip and bearing setup on your axle must match before installing.
Support the vehicle securely on stands before removing the axle shaft.
What’s included
The item is one passenger side axle shaft. Check bearings, seals, gaskets and retaining hardware against your installation before starting.









