Overview
The Timbren SES Suspension Upgrade, part number T/ITORTUN4L, is a rear rubber spring kit for the Toyota Tacoma with its OEM 3 leaf rear spring suspension, and for Nissan Titan and Frontier trucks. The leaf spring setup is part of the match for the Tacoma. Hollow rubber springs help keep the rear level when towing or carrying heavy bed loads.
Each steel piece is laser cut, welded and powder-coated for a precise fit. The kit replaces the jounce stop on the frame, and the springs adjust automatically as weight changes. The spring gap must be set correctly for good ride quality both loaded and unloaded.
Key features
- Hollow rubber springs that stiffen as more weight presses down
- Replaces the jounce stop on the frame
- Laser cut steel pieces that are welded and powder-coated
- Built for trailer towing and heavy bed loads, aiming to keep the rear level
- Ride quality designed for loaded and unloaded driving with a 1/2″ to 1-1/2″ spring gap
Leaf springs and auxiliary support
Leaf spring rear suspensions carry load through stacked spring plates, and they settle differently from coil setups when weight is added. An auxiliary rubber spring works alongside the leaves, adding support once the rear begins to compress. Because the leaves and the rubber springs share the load, the clearance between the rubber spring and the frame should be checked after fitting and again after any suspension work.
Leaf spring trucks often carry trailers or heavy beds, so the rear sees repeated loading. Inspect the leaf packs for cracked or loose plates, and check the shackles and bushings for wear. A worn leaf spring can change the way an auxiliary spring engages, so address those parts before or during the install. Tighten fasteners after the first short drive.
Specifications
| Brand | Timbren |
|---|---|
| Part number | T/ITORTUN4L |
| Application | Rear |
| System type | Rubber spring |
| Fitment category | Universal Fit |
| Material | Laser cut steel, welded, powder-coated |
| Spring gap | 1/2″ to 1-1/2″ between rubber spring and frame |
Vehicle fitment
The kit is matched to Toyota Tacoma trucks with OEM 3 leaf rear springs, plus Nissan Titan and Frontier. Match your year and model to that application before ordering.
Tacoma trucks with a rear suspension other than OEM 3 leaf springs are outside this application. Verify your year, model and trim before ordering.
Installation notes
Because the springs are set to a 1/2″ to 1-1/2″ gap from the frame, measure that gap after fitting and before loading the truck. The jounce stop is removed as part of the job, since this kit takes its place. Keep the truck safely raised and supported while the rear springs are handled.
What’s included
The kit described here is made of laser cut steel pieces and hollow rubber springs, with no separate parts called out.










