Select your vehicle

Rough Country Rear CV Drive Shaft (4″ Lift) – 5087.1

Rough Country

$299.95In stock
Buy on Amazon

See similar parts on Amazon

Price and availability as of Nov 18, 2026 8:40 PM MST, from Amazon.com, and subject to change. The Amazon listing has the current details.

Check out with your Amazon account. Amazon handles delivery and returns.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Rear CV driveshaft for 1994–1995 Jeep Wrangler YJ
  • Double cardan style, recommended for 4-inch lifts
  • Prevents driveline vibration and rear output shaft breakage
  • Extended length, direct fit
  • Slip yoke eliminator required

Description

Overview

The Rough Country Rear CV Drive Shaft (4-inch lift), part R/C5087.1, is a double cardan style rear driveshaft for the 1994–1995 Jeep Wrangler YJ. Rough Country recommends it for YJ models with a 4-inch suspension lift to prevent driveline vibration and breakage of the rear output shaft.

A slip yoke eliminator is required with this shaft. It fits the 1994–1995 Jeep Wrangler YJ only.

Key features

  • Double cardan style CV rear shaft
  • Recommended for YJ models with a 4-inch lift
  • Helps prevent driveline vibration
  • Helps prevent breakage of the rear output shaft
  • Extended length, direct fit

Slip yokes and eliminators

A slip yoke allows the driveshaft to change length as the rear axle moves on its springs. Replacing it with an eliminator fixes the shaft length, which makes a fixed-length shaft workable on a lifted setup. The trade-off is that the transmission output bearing then carries the load differently, so the work needs to be done carefully.

Once the eliminator is in, check the driveline angles and the rear pinion alignment. Look for vibration, a squeak from the output seal area or seepage from the transfer case. Keep fluid levels correct after any driveline change, since the seal may have been disturbed during the work.

  • Confirm transmission and transfer case output fit
  • Check driveline angles after install
  • Inspect seals for seepage
  • Keep transfer case fluid at the correct level

Specifications

Brand Rough Country
Part number R/C5087.1
Position Rear
Length Extended
Joint type CV, double cardan style
Recommended lift 4-inch
Slip yoke eliminator Required
Fitment type Direct fit

Vehicle fitment

It fits the 1994–1995 Jeep Wrangler (YJ), covering the YJ generation.

The 1987–1993 YJ and the 1997 and later TJ are not covered. Confirm fit for your vehicle’s year, model and trim before choosing this part.

Installation notes

Budget for a slip yoke eliminator, since this shaft requires one. This shaft is intended for a 4-inch YJ lift.

What’s included

One rear CV driveshaft. A slip yoke eliminator is not included and is required.

Fitment

VehicleYearsTrims
Jeep Wrangler (YJ)1994–1995Renegade, Rio Grande, S, SE, Sahara

Use “Select your vehicle” at the top of the page to check this part against your vehicle.

Questions & Answers

Does the R/C5087.1 fit a 1995 Jeep Wrangler YJ?

Yes, 1995 falls within the 1994–1995 Wrangler YJ range, and the shaft is for a 4-inch lift on that model.

Is a slip yoke eliminator needed?

Yes. A slip yoke eliminator is required with this rear shaft, so add one at the same time as the driveshaft.

Does this shaft fit a 1990 YJ?

Only 1994–1995 Wrangler YJ models are covered, so a 1990 YJ is outside this fit. Confirm your model year before choosing this part.

Can I drive a Wrangler YJ without the eliminator?

Not with this shaft, which requires one. Without the eliminator, the shaft can bind or slide under suspension travel, so fit the eliminator at the same time as the driveshaft.

Ready to order?

Order this part on Amazon and check out with your Amazon account. Amazon handles delivery and returns.

Buy on Amazon