Overview
It is a rear driveshaft assembly for the Ultimate Dana 60 rear axle, built on a 1350 series driveshaft. It is a direct fit for the 2007–2018 Jeep Wrangler (JK) in 2-door and 4-door models.
It is made from high-quality steel with extra thick tubing for added strength. A slip assembly at the transfer case end helps guard against impacts and contamination. All the hardware needed for a bolt-in fit is included.
Key features
- 1350 series driveshaft
- Extra thick tubing for durability on the trail
- Slip assembly at the transfer case
- All hardware for a bolt-in installation
- High-quality steel construction
Trail care for the driveshaft
A rear driveshaft carries power from the transfer case to the axle, and it runs at changing angles as the suspension moves. Steep joint angles cause vibration at speed, so ride height changes and worn joints should be considered together. Regular inspection helps catch problems early on rough trail use.
The slip assembly at the transfer case end allows the driveshaft to change length as the axle moves, so it needs to be kept clean and lubricated. Dirt or water inside the slip can cause sticking or wear, and a driveshaft that vibrates or clunks should be checked before it is used hard. Tightening the flange bolts and checking for run-out after a trail trip are simple steps that help.
- Check the slip for smooth movement
- Inspect U-joints for play after rough trails
- Tighten flange bolts after the first trail runs
- Look for rubbing marks on the tubing
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | D/S10113217 |
| Position | Rear |
| Driveshaft series | 1350 |
| Tubing | Extra thick |
| Slip location | Transfer case |
| Hardware | All included for bolt-in fit |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK), in 2-door and 4-door versions, with the Ultimate Dana 60 rear axle.
Only the 2007–2018 JK is covered. The JL, Gladiator, TJ, LJ and YJ are not.
What’s included
The rear driveshaft assembly with all of the hardware needed for a bolt-in installation.









