Overview
The G2 Axle and Gear pinion nut, part number 14-PN2, retains the pinion gear on its shaft during ring and pinion installation. Confirm the thread size and torque value for your axle before installing it.
Pinion preload basics
The pinion nut holds the pinion bearings in preload, which sets how tightly the bearings sit and keeps the gear mesh stable under load. Too little preload lets the pinion move and can damage the bearings, while too much pushes them into a hard fit that wears early. Setting preload is a slow process, so tighten in small steps and check rotational drag as you go.
Many installs replace the crush sleeve or collapsible spacer at the same time as the nut, since a reused spacer may not hold the correct preload. Inspect the pinion yoke or flange for scoring where the nut seats, and clean the threads before assembly.
- Check the yoke for scoring at the nut seat
- Replace crush sleeves when the design calls for them
- Use a torque wrench and check drag as you tighten
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 14-PN2 |
| UPC | 682034178810 |
| Part type | Pinion nut |
Vehicle fitment
Confirm the axle model and pinion size match before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion preload is set when the nut is tightened, so use the specified preload and a torque wrench rather than tightening by feel.
What’s included
The package contains one pinion nut.







