Overview
The G2 Axle and Gear Chrysler 9.25-inch Front (AAM) Minor Ring and Pinion Installation Kit, part number 25-2026, is a minor kit for the Chrysler 9.25-inch front axle. It is the AAM front version, with UPC 631410126594.
The listed parts are shims, seals, a pinion nut, a crush sleeve, bolts and three compounds or sealers.
Setup and seating checks
Front (AAM) minor kits are used to refresh a gear set’s shims, seals and fasteners rather than replace the full carrier. The pinion nut and crush sleeve are commonly replaced during the job, because a reused crush sleeve may not hold the correct preload. Shims set pinion depth and carrier bearing preload, so the old shim stack should be measured and compared with the new set.
Gear marking compound helps show tooth contact, and silicone sealer and thread locking compound are used on fasteners and housing surfaces. Clean all mating surfaces before assembly and apply compounds only where the job calls for them. Check the pinion seal surface for wear, and inspect the bearings for roughness before closing the axle.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2026 |
| UPC | 631410126594 |
| Kit type | Minor |
| Axle | Chrysler 9.25-inch, front (AAM) |
Vehicle fitment
It is for the Chrysler 9.25-inch front axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Thread locking compound, gear marking compound and silicone sealer come with the kit. Setting pinion depth and preload calls for a skilled gear technician.
What’s included
- Pinion nut
- Pinion seal
- Crush sleeve
- Pinion shims
- Carrier shims
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer







