Overview
The G2 Axle and Gear 35-2010 is a master ring and pinion installation kit for the GM 14 Bolt 9.5 Inches rear axle.
The 35-2010 is the master kit for the 14 bolt 9.5 inch axle. It also works in Chrysler 9.25 inch AAM front axles. It includes Timken pinion and carrier bearings with races, shim packs, a crush sleeve, nut and seal, ring gear bolts, and the compounds.
G2 builds the 35-2010 as a master kit for the GM 14 bolt 9.5 inch rear axle, with a note that it also works in Chrysler 9.25 inch AAM front axles. The contents renew the Timken pinion and carrier bearings with races and supply shims, a crush sleeve, nut, seal, bolts, thread locker, marking compound and silicone sealer for either application.
Key features
- Master installation kit for the GM 14 Bolt 9.5 Inches axle (rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Cross-brand fit checks
Cross-brand fits need extra checks because housings from different makers do not always share bearing and race sizes. Before pressing bearings, compare the race diameter and the carrier bore against the new parts, and confirm the pinion setup on the housing. Shim packs also differ, so measure them as you remove the old parts and keep them sorted by thickness.
Pinion depth and tooth contact are set with shims, a crush sleeve and gear marking compound, and the pattern should be read after each adjustment. Work slowly and check backlash with a dial indicator before the carrier goes back in. Keep the gear oil clean during the install, and run the axle through a careful break-in once the cover is closed.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2010 |
| UPC | 631410095500 |
| Kit type | Master kit with bearings |
| Axle location | Rear |
| Axle type | GM 14 Bolt 9.5 Inches |
| Axle manufacturer | GM |
Vehicle fitment
The 35-2010 is for GM 14 bolt 9.5 inch rear axles and also works in Chrysler 9.25 inch AAM front axles. Identify your axle by size and design, and verify your axle type, spline count and year before ordering.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
Using the kit in a Chrysler AAM front axle is a cross-brand application, so verify bearing and race sizes against your housing before pressing anything. Set depth with shims and check the pattern afterward.
Before opening the GM 14 Bolt 9.5 Inches housing for the 35-2010 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2010 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2010 supplies installation parts for the GM 14 Bolt 9.5 Inches axle only.












