Overview
The G2 Axle and Gear 35-2049ARB is a master ring and pinion installation kit for Dana 35 rear axles fitted with an ARB Air Locker.
Rebuilding the rear differential of a Dana 35 that carries an ARB Air Locker takes more than a gear set. This G2 kit supplies the Timken pinion bearing set, pinion nut, seal, crush sleeve, both shim packs, ring gear bolts and the three shop compounds, so the parts that stores often lack arrive together. Carrier bearings are the exception and must be bought separately.
Why the locker matters: an ARB Air Locker replaces the open differential in the carrier, so the gear set is shimmed around that carrier. G2 builds this kit around the pinion side, giving the installer fresh Timken pinion bearings and races, the crush sleeve and the shim packs. Because carrier bearings are not in the box, the installer should have those on hand before the axle is opened, so the job is not stalled halfway through.
Key features
- Master installation kit for the Dana 35 axle (rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes ring Gear Bolts
- Includes thread Locking Compound
Locker carrier planning
A Dana 35 with an ARB Air Locker is a locker-specific job. The carrier is shimmed around the locker, so the setup differs from a standard open Dana 35. Plan the parts list before opening the housing, and keep the carrier bearings, races and any locker-specific parts ready. Working from a clean bench helps keep the shims in order.
The pinion side is the easiest part to set once the depth is known. Measure the old pinion, then match the new shims to the pattern you need. Use a dial indicator and a torque wrench, and check the pattern with marking compound before closing the housing. Replacing the crush sleeve and pinion nut at the same time avoids preload problems later.
- Gather a dial indicator and torque wrench
- Record the original gear pattern
- Order carrier bearings before opening the housing
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2049ARB |
| UPC | 631410116373 |
| Kit type | Master kit |
| Axle location | Rear |
| Axle type | Dana 35 |
| Axle manufacturer | Dana |
Vehicle fitment
It is for Dana 35 rear axles fitted with an ARB Air Locker only, and it is outside its intended use on a Dana 35 without that locker. Match the kit to your axle and locker before ordering.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
An air locker carrier changes how the gear set is shimmed and checked, so the job suits a shop with ring and pinion experience. The crush sleeve is a single-use part, and the included marking compound lets the installer read the tooth pattern before the housing is closed up.
Before opening the Dana 35 housing for the 35-2049ARB job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2049ARB shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness. Order carrier bearings and races separately and have them ready.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: carrier bearings and gears; the 35-2049ARB is an installation parts kit only.









