Overview
The G2 Axle and Gear 4-TJ-456M is a 4.56 ring and pinion gear set with front and rear minor installation kits for the 1997–2006 Jeep Wrangler TJ. The kit pairs a 4.56 front gear set for the Dana 30 front axle with a 4.56 rear gear set for the Dana 35 rear axle, so both axles of the Jeep are regeared in one kit.
The 4-TJ-456M gives Wrangler TJ owners a 4.56 option for changing axle gearing. Its gears are engineered for oversized tires and high performance engines. It fits non-Rubicon models.
Key features
- Complete front and rear set: 4.56 ring and pinion gear sets for both axles plus matched minor installation kits
- Built for the Dana 30 front axle and the Dana 35 rear axle
- Computer heat treated 8620 steel gears
- Manufactured to O.E. specifications.
- Double shot peened and double lapped gear sets
- Limited lifetime warranty listed by G2
- Fits non-Rubicon models.
Choosing a gear swap
Changing gear ratio is a larger job than swapping a single part, because both axles and their carriers change at once. A higher numerical ratio gives more pulling power at low speed and can help with heavier tires, while it also raises engine speed on the highway. Before buying, measure your current tire diameter and think about how the Jeep is used, whether mostly on pavement, on trails, or towing.
Gear swaps are often paired with related parts. Bearings, seals and the carrier are commonly inspected or renewed during the same job, and correct shim setting with a backlash and tooth contact check keeps the new gears quiet and durable. Keep a torque wrench and fresh gear oil on hand, then re-check the housing bolts and fluid level after the first few trail runs.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-TJ-456M |
| UPC | 631410141184 |
| Product type | Ring and pinion gear sets with front and rear minor installation kits |
| Gear ratio | 4.56 |
| Vehicle named in listing | 1997–2006 Jeep Wrangler TJ |
| Front axle | Dana 30 |
| Trim note | Non-Rubicon models |
| Rear axle | Dana 35 |
| Axle location | Front and rear |
| Kit type | Minor kit |
| Gear material | Computer heat treated 8620 steel |
| Finishing | Double shot peened, double lapped |
| Manufacturing | Manufactured to O.E. specs |
| Warranty | Limited lifetime warranty |
Vehicle fitment
It fits the 1997–2006 Jeep Wrangler TJ (97-06 Wrangler TJ) with a Dana 30 front axle and a Dana 35 rear axle.
The 4-TJ-456M listing does not cover the earlier Wrangler YJ (1987–1995), the Wrangler JK (2007–2018) and other Jeep models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting the 4-TJ-456M changes the gear ratio on both axles of a Wrangler TJ, which is work for an experienced gear installer. The two minor installation kits in the 4-TJ-456M are the parts used for setting the new gears, and the same 4.56 ratio goes in both axles so the drivetrain stays matched. The 4-TJ-456M is a minor kit, and bearing sets are not among its listed contents. Plan a careful break-in for the new 4-TJ-456M gears after installation.
What’s included
- Front ring and pinion gear set, 4.56
- Rear ring and pinion gear set, 4.56
- Front minor installation kit
- Rear minor installation kit









