Overview
The G2 Axle and Gear 35-2081 is a master ring and pinion installation kit for the Suzuki 6.875 Inches front and rear axle.
Small 4x4s with the 6.875 inch Suzuki differential are covered by the 35-2081. G2 includes Timken pinion and carrier bearings with races, pinion and carrier shims, a crush sleeve, pinion nut and seal, ring gear bolts, and sealing and marking compounds.
G2 keeps the Suzuki Samurai on its own kit because the 6.875 inch differential is small and unlike the others in this family. The 35-2081 serves either end of the vehicle, and its Timken bearings with races, shims, crush sleeve, pinion nut and seal, ring gear bolts, thread locker, marking compound and silicone sealer cover the complete gear install.
Key features
- Master installation kit for the Suzuki 6.875 Inches axle (front and rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Tooth pattern and shim checks
Small differentials leave little room for error, so each step of a 6.875 inch gear install deserves patience. Bearing races must seat fully and square in the carrier and housing before the new gears are set. A bearing that sits crooked can make a good gear set look wrong on the tooth pattern.
Check the pattern in both drive and coast, then adjust pinion depth in small steps with the shims. Recheck backlash after each change, since pinion and carrier settings interact. Work on a clean bench and keep the shims separated so the original thickness can be recovered if needed.
- Seat races with a proper driver, not a hammer
- Record shim packs before pulling the pinion
- Inspect carrier bearing bores for wear
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2081 |
| UPC | 631410119183 |
| Kit type | Master kit with bearings |
| Axle location | Front and rear |
| Axle type | Suzuki 6.875 Inches |
| Axle manufacturer | Other |
Vehicle fitment
It fits Suzuki 6.875 inch axles in front or rear positions, and it is sold under the Samurai name. Verify the differential size on your axle before ordering, since the housing size decides the fit.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
Suzuki differentials are small, so bearing fit matters; check race sizes when you press them in. Set pinion depth with the shims, then use the marking compound to read the tooth pattern.
Before opening the Suzuki 6.875 Inches housing for the 35-2081 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2081 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2081 supplies installation parts for the Suzuki 6.875 Inches axle only.












