Overview
The Jeep 68038761AA is a rear ring and pinion gear set with a 3.73 gear ratio for Dana 44 JK axles. It uses factory-style gear design, so the set suits replacing or upgrading gearing on a Wrangler JK rear axle. It is for the rear axle only.
Key features
- 3.73 gear ratio
- Dana 44 JK rear axle application
- Factory-style gear design for the Dana 44 JK rear axle
- 1/2in. bolt size.
Gear ratio and tire size
Gear ratio decides how the engine’s power is spread across the tire’s rotation. A numerically higher ratio gives stronger low-speed pulling and quicker response, while a lower ratio helps highway cruising. Tire diameter changes the effective ratio, so a larger tire can make a gear set feel lower than expected on the road.
A ring and pinion swap is a good time to check related parts. Pinion and carrier bearings, the pinion seal and the carrier shims often come off or get inspected during the job. Installing new gears on worn bearings can shorten the life of the new set, so many owners replace those parts together.
- Check tire diameter before choosing a ratio
- Replace the pinion seal during the install
- Verify backlash on the new gears before final assembly
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68038761AA |
| Gear ratio | 3.73 |
| Axle manufacturer | Dana |
| Axle type | Dana 44 JK |
| Axle location | Rear |
| Bolt size | 1/2in. |
Vehicle fitment
It fits Jeep Wrangler JK models with a Dana 44 JK rear axle.
Front axle gears and other Wrangler generations are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Gear mesh and bearing preload should be set by a professional, and new gears should be broken in before heavy use.
What’s included
A rear ring and pinion gear set.
Not included: Pinion and carrier bearings, the carrier and installation hardware are not included. Compare the box contents with your installation plan before you start.








