Overview
The G2 Axle and Gear 35-2042 is a master ring and pinion installation kit for Toyota 7.5 inch axles with small bearings. Its install hardware covers pinion and carrier bearings, shims, a crush sleeve and seals needed for a gear swap.
The kit fits both front and rear locations and is sold as universal fit, so the 7.5 inch axle size decides fit rather than a vehicle model.
Key features
- Master kit with bearings for Toyota 7.5 inch axles
- Shim kit and replacement pinion nut
- Crush sleeve, pinion seal and pinion bearings
- Carrier bearings, ring gear bolts and silicone sealer
- Loctite and gear marking compound for setup checks
Small bearing kit basics
Small bearing carriers rely on the correct pinion bearing preload and carrier bearing fit, so the install parts should match the carrier you are working on. Pinion depth is the first setting to get right, because it drives the tooth pattern once the gears are in.
When a gear set is replaced, the pinion nut and crush sleeve are commonly changed as well, since the old crush sleeve cannot be reused. Keep the old shims together until the new setup is confirmed, in case you need to restore a known starting point.
- Confirm the carrier bearing type before ordering
- Replace the crush sleeve during the install
- Keep old shims until setup is confirmed
- Inspect the old carrier for wear before reuse
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2042 |
| UPC | 631410095906 |
| Axle manufacturer | Toyota |
| Axle type | Toyota 7.5 Inches |
| Axle location | Front and rear |
| Bearing type | Small bearing |
| Kit type | Master kit with bearings |
Vehicle fitment
Fit follows the 7.5 inch axle size, so the axle is the detail to verify before ordering.
A 7.5 inch kit does not cover Toyota axles of other sizes. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A small bearing kit still needs careful setup: pinion depth and carrier preload are set first, then tooth contact is checked with gear marking compound. If this is new work, a professional should handle the setup and break-in.
What’s included
The kit includes a shim kit, replacement pinion nut, crush sleeve, pinion seal, pinion bearings, carrier bearings, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Not included: Ring and pinion gears are sold separately and must be sourced for the install.
