Overview
The G2 Axle and Gear 35-2018 is a master ring and pinion installation kit with bearings for the GM 12 bolt truck, 8.875-inch axle, for the rear axle position.
The 35-2018 follows G2’s master kit approach: it includes the parts needed to properly install a ring and pinion, with pinion bearings and carrier bearings along with the shims, nut, seal and compounds. G2 says some of the parts in the 35-2018 are hard to find items that auto parts stores rarely stock. The 35-2018 does not contain the ring and pinion gear set itself.
Key features
- Master kit with bearings for the GM 12 bolt truck, 8.875-inch axle
- Timken outer and inner pinion bearings and races
- Pinion shims and carrier shims
- Carrier bearings and races included
- Pinion nut, crush sleeve, pinion seal and ring gear bolts
- Thread locking compound, gear marking compound and silicone sealer
Setup and break-in
A master kit replaces the pinion and carrier bearings along with the gear set, so the work is best approached as a full rebuild rather than a partial repair. Before assembly, clean the carrier and inspect the case for cracks, worn bearing bores and damaged bearing seats. A bore that has spun or galled will affect pinion depth and preload, and it is far easier to address that before the gears are set.
Gear marking compound shows tooth contact, and small shim changes move the pattern. Keep notes on every shim change and recheck preload after the first few miles of driving. Use thread locking compound only where the fastener calls for it, and clean threads before applying it.
- Inspect pinion and carrier bearing bores before installing
- Keep a written record of each shim change
- Recheck bolts and preload after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2018 |
| UPC | 631410095630 |
| Product type | Master ring and pinion installation kit with bearings |
| Axle | GM 12 bolt truck, 8.875-inch |
| Axle location | Rear |
| Popular axle manufacturer | GM |
| Kit type | Master kit with bearings |
| Contents | Pinion nut, pinion seal, Timken outer pinion bearing and race, crush sleeve, Timken inner pinion bearing and race, pinion shims, carrier shims, carrier bearings and races, ring gear bolts, thread locking compound, gear marking compound, silicone sealer |
Vehicle fitment
The 35-2018 is identified by axle rather than by vehicle: it is made for the GM 12 bolt truck, 8.875-inch axle in the rear position. Check your axle housing before ordering.
It is not made for other axle designs or sizes, so check that your axle is a GM 12 bolt truck with an 8.875-inch housing before ordering.
Installation notes
A master kit such as the 35-2018 rebuilds the gear setup completely, so the bearings are replaced along with the gear set. The pinion shims, carrier shims, crush sleeve and gear marking compound in the 35-2018 are the parts used to set pinion depth, preload and the tooth contact pattern, which calls for an installer with gear setup experience and a careful break-in afterwards.
What’s included
- Pinion nut
- Pinion seal
- Timken outer pinion bearing and race
- Crush sleeve
- Timken inner pinion bearing and race
- Pinion shims
- Carrier shims
- Carrier bearings and races
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer
Not included with the 35-2018: ring and pinion gear set.














