Offroad Racing Fog & Driving Lights
Showing 481–492 of 537 resultsSorted by popularity
-
-
Offroad Racing Fog & Driving Lights
Rigid Industries SR-Series Single Row 10 Deg. Spot/20 Deg. Flood Combo LED Light – 910322
Offroad Racing Fog & Driving LightsRigid Industries SR-Series Single Row 10 Deg. Spot/20 Deg. Flood Combo LED Light – 910322
- Universal fit: a 10 inch surface mount LED combo light
- Part number 910322, single row SR-Series
- 10 degree spot and 20 degree flood combo
- Hybrid design with 10 amber LEDs, sold as 2 pieces
SKU: RIG910322 -
-
-
Offroad Racing Fog & Driving Lights
Rigid Industries Truck-Lite 7 Inch Round LED Heated Headlamp Kit (Black) – 55008
Offroad Racing Fog & Driving LightsRigid Industries Truck-Lite 7 Inch Round LED Heated Headlamp Kit (Black) – 55008
- Rigid Industries Truck-Lite 7 inch round LED heated headlamp kit, black, part number 55008
- Heated lens turns on below 50 degrees F
- Omni-Volt design for 12 and 24 volt systems
- Sold as a pair, 3.6 amp high beam and 1.8 amp low beam
SKU: RIG55008 -
-
Offroad Racing Fog & Driving Lights
Rigid Industries SR-Series Pro 20 Inch Light Bar (Combo) – 921314
Offroad Racing Fog & Driving LightsRigid Industries SR-Series Pro 20 Inch Light Bar (Combo) – 921314
- Rigid Industries SR-Series Pro 20 inch light bar, spot/drive combo, part number 921314
- 132 watts, 22 LEDs, 17424 raw lumens
- Under 2 inches tall, Specter optics
- 50,000+ hour lifespan, black finish
SKU: RIG921314 -
-
Offroad Racing Fog & Driving Lights
E-Series Midnight Optic Spot Light
- 20-inch spot light bar with a black enamel Midnight Optic finish
- 40 white LEDs behind a hybrid spot optic
- Transparent black enamel coating and black oxide hardware
- Surface mount on a bracket, sold as a single light
SKU: RIG120213BLK -
-
-
Offroad Racing Fog & Driving Lights
Rigid Industries Ignite LED Backup Light Kit – Flush Mount (Black) – 20641
Offroad Racing Fog & Driving LightsRigid Industries Ignite LED Backup Light Kit – Flush Mount (Black) – 20641
- Pair of flush mount LED backup lights, 1000 raw lumens each
- Diffused beam, black finish, IP68 compliant
- Operates on 6-28 VDC; each light uses under one amp
- Wiring harness not included
SKU: RIG20641
Light types and what they do
Auxiliary lights are not interchangeable. Driving lights throw a focused beam far down the road. Fog lights are mounted low and use a wide, flat pattern to light the ground close to the vehicle without bouncing glare off dust, rain or snow. Light pods are compact cubes that suit bumpers-bumpers-tire-carriers-winch-mounts-2, A-pillars and rock lighting. Light bars deliver a lot of output across a long, narrow housing and are common on roofs and bumpers.
Beam pattern and lens color
- Spot: Narrow and long reaching, good for high-speed travel.
- Flood: Wide and short, good for slow trail work and camp tasks.
- Combo: Mixes both patterns in one light for general use.
- Driving/fog patterns: Engineered for specific cutoffs and mounting heights.
Amber or yellow lenses cut glare in dust, fog and snow, while clear or white lenses give the most natural color rendering. Some listings include a colored backlight, which is decorative and does not change the main beam.
Specifications worth comparing
Lumens and watts are easy to advertise but do not tell the whole story, because optics control where the light goes. Look at the beam pattern, housing material, lens material and ingress protection rating for dust and water. Check the operating voltage, current draw and whether the light includes a harness, relay and switch. Heat sinking matters for LEDs, so look for solid metal housings rather than thin shells.
Wiring and installation
High-output lights should be wired through a relay with a properly sized fuse and wire gauge, not directly off a factory switch. Seal connections and route wiring away from heat and moving parts. Aim lights so they do not blind oncoming drivers, and cover them on public roads where required.
Legal and fitment notes
Lighting rules differ by state, and many off-road lights are intended for off-highway use only. Check local regulations before using them on paved roads. Fitment is listed as universal on many products, but mounting brackets, grille cutouts and bumper tabs vary, so confirm fitment for your exact year, make and model and read the manufacturer's specifications.
Keep the lenses clean and check that the mounting hardware stays tight, since washboard roads loosen bolts over time. Mud and dust cut output sharply, so a quick wipe before a night run is worthwhile. If a light flickers, inspect the connector seals and ground point first, because poor grounds cause most intermittent faults.
A few pairing ideas help when planning a lighting setup. A bumper-mounted pair of fog or driving lights covers close and mid range, while a roof or windshield bar adds long-range reach. Keep switches labeled and place a master switch within reach, so every light can be turned off quickly when meeting traffic. Using separate switches for spot and flood patterns lets you change the light to suit the terrain, and a dash indicator confirms what is on. Check that the combined current draw stays within the alternator's spare capacity and the circuit fuse rating, particularly if you also run a winch and a compressor.
When comparing similar-looking lights, confirm that the lens is polycarbonate or tempered glass, that the housing carries a rating for dust and immersion, and that mounting brackets are included. Heavy lights on thin brackets vibrate and can crack mounts.
Popular Offroad Racing Fog & Driving Lights brands
- Rigid Industries (249)
- Baja Designs (59)
- KC HiLites (57)
- Oracle Lighting (23)
- Hella (22)
- Pro Comp Suspension (21)
- Rough Country (20)
- ARB 4x4 Accessories (14)
- DV8 Offroad (13)
- JW Speaker (13)
- Piaa Lighting (12)
- Smittybilt (12)
Shop Offroad Racing Fog & Driving Lights by type
- Light Bars (195)
- Fog Lights (62)
- Light Pods (50)
- Driving Lights (37)
- Offroad Auxiliary Lights (27)
- Offroad Light Packages (19)
- Grille LED Light Kits (15)
- Offroad Light Wiring and Switches (9)
Offroad Racing Fog & Driving Lights FAQ
What is the difference between fog lights and driving lights?
Fog lights use a wide, low pattern that lights the ground near the vehicle and limits glare in dust or rain. Driving lights project a longer, narrower beam to see farther at speed. Many drivers run both.
Are LED off-road lights street legal?
It depends on the light and where you drive. Many off-road lights are labeled for off-highway use only, and rules differ by state. Check local regulations and the manufacturer's notes, and cover lights on public roads if required.
Do I need a relay to install a light bar?
In most cases yes. A relay lets the switch control the circuit without carrying the full current, and a fuse near the battery protects the wiring. Follow the wiring kit instructions and use wire sized for the light's current draw.
Should I choose spot, flood or combo beams?
Spot beams reach farthest and suit fast open roads, flood beams spread light for slow trails and camp use, and combo beams split the difference. Many setups pair a spot bar up high with floods or fog lights low.







