Overview
The Poison Spyder Laser Fit Fully Welded Cage Kit with Grab Handles, bare steel, part number 15-19-010-WG, is a complete roll cage that comes professionally welded and ready to bolt into the Jeep. The LJ Full Cage incorporates Poison Spyder’s proprietary lower A-pillars, so the cage is written for the Jeep LJ, 2004 to 2006.
The cage starts from the Lazer-Fit Full Cage Kit, which is CNC laser notched and NC bent for a precise fit. Poison Spyder then welds the kit together in its precision fixtures, so the buyer does not have to weld the cage. The kit suits owners without access to a welder, or anyone who prefers not to weld the cage themselves.
Key features
- Fully welded and ready to bolt in
- Grab handles included
- Lazer-Fit tubing, laser notched and NC bent
- All Poison Spyder cages use 100 percent DOM structural tubing
- Lower A-pillars and gussets are CNC laser cut from high strength 3/16 inch plate steel
- Does not work with bowless soft tops, which need a bow assembly
Preparing the roof and soft top
A roll cage changes how the body and roof share load. When the cage is bolted to the tub and the roof frame, the upper structure carries forces that were previously taken by the soft top frame alone. Before installation, confirm the roof, windshield frame and door openings are in good condition, since loose or corroded mounting areas affect how well the cage holds.
Soft tops and cages must work together. A top with bows that fit well keeps the fabric tight against the cage tubing, while a poor fit can sag and rub. Check the top’s fit after the cage is in place, and look for chafing at the bows and seams. Over time, inspect the cage’s welds and mounting points each trail season, because flexing and impact can crack a weld at a stress point.
- Check soft top bows for fit against the cage
- Inspect welds at mounting points each season
- Look for chafing where fabric meets tubing
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 15-19-010-WG |
| UPC | 614901726527 |
| Type | Fully welded roll cage with grab handles |
| Finish | Bare steel |
| Tubing | 1.75 inch by .120 wall DOM |
| Plate steel | High strength 3/16 inch |
| Installation | Bolt in, cage welded at the factory |
| Soft top compatibility | Not for bowless soft tops; bow assembly required |
Vehicle fitment
The welded cage fits the Jeep LJ, 2004 to 2006. Confirm your Jeep is an LJ before ordering, and check the body and roof against the cage mounting points before fitting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The cage arrives welded and bolts in, so no welding is needed on the vehicle. Check that your soft top has a bow assembly, since bowless soft tops do not work with this cage. Confirm the mounting points line up before the final bolts go in. Check that your soft top has a bow assembly before fitting the cage, since bowless tops are not compatible. The welded cage is supplied ready to bolt in.
What’s included
The fully welded Full Cage with grab handles and the mounting hardware.
