Overview
The Poison Spyder Lower A-Pillar Kit, bare steel, part number 14-18-011, is a pair of lower A-pillars for building a cage on the Jeep TJ and LJ. The kit ties the cage A-pillars securely to the floor, and it is written for the Wrangler TJ, 1997 to 2006, and the Wrangler LJ, 2004 to 2006.
The pillars are engineered to give the forward section of the cage a solid base while staying close to the dash. The result is a low profile cage that does not get in the way of getting in or of legroom. These are the same components Poison Spyder uses in its production TJ and LJ cages.
Key features
- Driver side and passenger side pillars sold as a pair
- 3/16 inch plate steel, CNC laser cut and precision brake-formed
- Gussets come unwelded for TIG or MIG welding
- Low profile fit around the dash
- Used in Poison Spyder’s production TJ and LJ cages
- Secures the cage to the floor
Before you weld
Lower A-pillars carry load from the roll cage into the floor, so weld quality at the base matters as much as the pillar itself. Before cutting or tacking, dry-fit the pillar against the dash, floor and cage tubing, and check that the cage bars line up without forcing them. A pillar that is pulled into place will stress the welds once the cage is loaded.
Choosing the right setup means thinking about the rest of the cage. Door bars, rear sections and bar lengths all change how forces travel through the A-pillar base. Plan the full cage layout first, then weld the pillars as the cage is built, working in short sections so heat does not distort the plate.
- Dry-fit before the first tack weld
- Keep gusset welds even on both sides
- Re-check cage alignment after each section
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-18-011 |
| UPC | 614901725865 |
| Type | Lower A-pillar kit |
| Finish | Bare steel |
| Material | 3/16 inch plate steel |
| Quantity | Pair, driver and passenger sides |
| Installation | Weld in |
Vehicle fitment
These A-pillars are written for the Jeep Wrangler TJ and LJ. The TJ is 1997 to 2006 and the LJ is 2004 to 2006. Confirm your Jeep is one of those two models before ordering, and that the pillars suit the dash of your body.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Weld-in installation is required. The gussets are unwelded, so they are welded with TIG or MIG as the cage is built. Check the fit around the dash before the final welds, since the pillars are shaped to follow it.
What’s included
A driver side and passenger side lower A-pillar, with the gussets as needed.












