Overview
The Poison Spyder Hood Louver in black powder coat, part number 14-53-011-PC, is a Jeep hood vent built for airflow through the engine compartment. It has two washer nozzle ports and is cut from thick aluminum sheet. The louver is sold for Jeep hoods, though no model years or chassis codes are named, so fitment is not confirmed here. Its black finish is part of the louver as supplied, not a separate paint job.
Under-hood heat rises to the top of the engine bay and collects there, especially at low speed when little air moves through the compartment. Venting that upper space allows the hot air to exit, and cooler air comes through the radiator to replace it. The louver is intended to keep the engine coolant and the air under the hood at lower temperatures.
Key features
- Black powder coat finish
- Two washer nozzle ports
- CNC laser-cut and die-stamped
- Light weight aluminum that resists corrosion
- Thick gauge sheet that adds hood rigidity
- Stainless steel fasteners
Hood vent airflow
Under-hood heat tends to collect near the top of the engine bay, where a closed hood traps warm air. A vent in the hood lets that air escape, which can reduce heat soak when the vehicle is stopped or moving slowly. Vent placement matters, so the opening should sit where hot air gathers and not over a part that needs direct access.
Hood louvers also add an opening that lets water, mud and dust in. Plan to check the engine bay after wet trail runs and keep the hood latch and seals in good order so the hood still closes firmly.
- Check the washer nozzle positions before cutting
- Look for wiring or hoses behind the planned opening
- Inspect hood latches and seals after heavy trail use
- Clean debris from the vent area periodically
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-53-011-PC |
| UPC | 614901726114 |
| Finish | Black powder coat |
| Material | Aluminum sheet, thick gauge |
| Construction | CNC laser-cut and die-stamped |
| Washer nozzle ports | 2 |
| Fasteners | Stainless steel |
| Template | Full size, with instructions |
Vehicle fitment
Check the hood on your vehicle against the template before you cut. The fitment for each Jeep hood should be confirmed for year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Drilling and cutting the hood are part of the install. The template shows the airflow openings, and the two washer nozzle ports need to be positioned against the washer nozzles on your vehicle. Stainless steel fasteners are supplied with the louver.
Two washer nozzle ports are built into this version, so check both against the nozzles on your vehicle. The bare aluminum version of this louver, 14-53-011, is a separate part number.
What’s included
One black powder coated hood louver with two washer nozzle ports, stainless steel fasteners, a full-size template and instructions.
