Overview
The G2 Axle and Gear GM 9.5 Inch Minor Ring and Pinion Installation Kit, part number 25-2010A, is a minor kit for the GM 9.5-inch axle. It carries UPC 631410126679 and is listed in the ring and pinion installation kit category.
The kit provides a pinion nut, pinion seal, crush sleeve, shims, ring gear bolts and assembly compounds, as itemized below.
Shims and setup
Shims control where the gears sit in the carrier and housing. Pinion shims set the depth of the pinion gear, while carrier shims set the ring gear mesh and bearing preload from the other side. Small changes in shim stack move the contact pattern, so measure each shim, record its thickness and reuse them carefully during a rebuild.
Setup compounds have specific jobs. Thread locking compound holds bolts that could back out under load, gear marking compound shows the tooth contact pattern during a test fit, and silicone sealer seals mating surfaces. Clean the surfaces before applying any of them, and follow the curing guidance on each container.
- Record each shim thickness before removing it
- Clean bolt threads before applying locking compound
- Replace the crush sleeve on every pinion removal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2010A |
| UPC | 631410126679 |
| Kit type | Minor |
| Axle | GM 9.5 Inch |
Vehicle fitment
It is for the GM 9.5-inch axle. Check year, model and trim against your vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes thread locking compound, gear marking compound and silicone sealer. Pinion depth and preload still need a skilled gear technician to set.
What’s included
- Pinion nut
- Pinion seal
- Crush sleeve
- Pinion shims
- Carrier shims
- Ring gear bolts
- Thread locking compound
- Gear marking compound
- Silicone sealer









