Overview
The G2 Axle and Gear 35-2013 is a master ring and pinion installation kit for the Ford 8.8 Inches rear axle.
The 35-2013 targets the early Ford 8.8 inch rear axle. G2 packs in Timken pinion bearings with races, carrier bearings with races, pinion and carrier shims, a crush sleeve, nut, seal, ring gear bolts, and the sealer and compounds used to finish the job in one box.
G2 splits its Ford 8.8 inch kits by era, and this 35-2013 is the early one for axles through 2008. Everything that turns with the pinion and carrier is renewed: Timken bearings and races, shims and bolts. The pinion seal and silicone sealer keep gear oil inside the housing, and the marking compound shows how the teeth meet once the setup is done.
Key features
- Master installation kit for the Ford 8.8 Inches axle (rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Setting pinion depth and preload
Pinion depth on a Ford 8.8 is controlled by shims behind the inner bearing race, and the crush sleeve sets preload. Work through depth first, then preload, then backlash, because each adjustment shifts the others. Keep the old shims in order and note which direction the pattern moved so the next change is easier to judge.
Marking compound gives a quick read, but judge both the drive and coast sides before changing a shim. Reusing old bearing races with new gears is a poor idea, since the wear pattern no longer matches the new contact. While the cover is off, inspect the carrier bearing bores and the housing for scoring.
- Clean the housing and the drain plug area before assembly
- Lubricate bearings with clean gear oil as they go in
- Set pinion depth before preload to avoid rework
- Replace the crush sleeve rather than reusing it
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2013 |
| UPC | 631410095586 |
| Kit type | Master kit with bearings |
| Axle location | Rear |
| Axle type | Ford 8.8 Inches |
| Axle manufacturer | Ford |
Vehicle fitment
It fits Ford 8.8 inch rear axles from 2008 and earlier. Later 8.8 inch axles are outside that range. Identify your axle first, because fit depends on the axle rather than the vehicle model.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
On a Ford 8.8 the pinion depth shims sit behind the inner bearing race and the crush sleeve sets pinion preload, so a careful installer will measure before closing the housing. Marking compound shows the final pattern.
Before opening the Ford 8.8 Inches housing for the 35-2013 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2013 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2013 supplies installation parts for the Ford 8.8 Inches axle only.













