Overview
The G2 Axle and Gear 25-2018 is a minor ring and pinion installation kit for the GM 12 Bolt 8.875 Inches rear axle.
Truck-side GM 12 bolt rear axles are the target of the 25-2018. G2 supplies the proper shim kit, pinion nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, and leaves bearings out on purpose.
For GM 12 bolt trucks, the 25-2018 brings together the small, specific parts for a gear set job: a shim kit for correcting pinion depth, a new pinion nut, crush sleeve and seal, new ring gear bolts, and the compounds that help assembly and pattern checks.
Key features
- Minor kit for the GM 12 Bolt 8.875 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Setting pinion depth
Pinion depth decides where the ring and pinion teeth meet, and it is the reason a shim kit is part of any gear set job. Shims go behind the pinion head and are changed in small steps until the marking compound shows a correct pattern on the ring gear. Expect to repeat the check a few times before the pattern settles.
The pinion nut and crush sleeve set bearing preload, so tighten them gradually and avoid overtightening, which can crush the sleeve beyond its intended setting. Use fresh ring gear bolts and apply the threadlocker as the instructions direct. A clean carrier and fresh gear oil also help the gears run quietly once the job is done.
- Clean the carrier and housing before assembly
- Note the old shim thickness before removal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2018 |
| UPC | 631410094909 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | GM 12 Bolt 8.875 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2018 |
Vehicle fitment
It is the truck version for the rear GM 12 bolt 8.875 inch axle. Check your axle type and year before ordering.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
Because the bearings stay, inspect them and their races for wear before reusing them. The shims then set pinion depth, and the marking compound shows the pattern.
Before starting the 25-2018 job on the GM 12 Bolt 8.875 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2018 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2018 is a minor kit for the GM 12 Bolt 8.875 Inches axle.






