Overview
The G2 Axle and Gear 35-2149 is a rear master install kit for the Dana 35 AdvanTEK M200 differential. It is a master kit with bearings, so the install components and bearings come together for a rear differential build.
Rear differential parts from this maker include ring and pinion sets, locking differentials, axle shafts, hubs and housings, all designed for four-wheel-drive use.
Key features
- Rear master install kit for the Dana 35 AdvanTEK M200
- Master kit with bearings
- Dana 35 AdvanTEK axle type.
- G2 also offers ring and pinions, locking differentials, shafts and hubs
Rear differential rebuilds
A rear differential rebuild starts with confirming the housing and carrier match the kit before any parts come off. The master kit groups bearings with the other install components, which keeps a build organized. Rear carriers take drive from the driveshaft, so the gear mesh and preload must be right or noise and early wear follow.
When choosing parts for a rear Dana 35 AdvanTEK, look at ring and pinion sets, locking differential choice and axle shaft condition together. Changing the gear ratio later usually means new bearings and shims are needed as well. Fluid and seals should be replaced during the build, and the carrier should be cleaned of old debris before new parts go in.
- Check the housing for cracks before reusing it
- Replace axle seals when the axle is opened
- Use fresh gear oil at the end of the build
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2149 |
| Axle type | Dana 35 AdvanTEK |
| Differential | M200 |
| Axle location | Rear |
| Kit type | Master kit with bearings |
Vehicle fitment
This kit is for a rear Dana 35 AdvanTEK M200 differential, which is an axle designation rather than a vehicle. Confirm fit for your vehicle’s year, model and trim before ordering, and match the housing and differential type to the kit.
The kit is for a rear Dana 35 AdvanTEK M200. Check the axle type before ordering.
Installation notes
Check the rear housing and differential type before fitting, because the kit is made for the Dana 35 AdvanTEK M200 only. A differential build should be carried out by someone experienced with gear setup and bearing preload.
What’s included
A master kit with bearings for the rear differential. Check the package contents against your build before starting.
























