Overview
The G2 Axle and Gear 25-2022 is a minor ring and pinion installation kit for the GM 10 Bolt 8.6 Inches rear axle.
The 25-2022 serves the GM 10 bolt 8.6 inch rear axle on 1999 and later builds. The kit holds a shim kit, nut, crush sleeve, pinion seal, ring gear bolts, silicone sealer, Loctite and gear marking compound, without bearings.
The kit sets the gears without addressing the bearings, so it suits installers who are keeping the existing bearings. It supplies the shim kit, nut, crush sleeve, seal, bolts and compounds needed to set the gears. A master version, 35-2022, includes new Timken bearings for installers who want them.
Key features
- Minor kit for the GM 10 Bolt 8.6 Inches axle (rear)
- Meant for jobs that keep the existing bearings
- Shim kit for setting pinion depth and carrier position
- Pinion nut, crush sleeve and pinion seal
- Ring gear bolts and silicone sealer
- Loctite and gear marking compound
Working on the 8.6 inch carrier
On the 8.6 inch axle, the pinion shims sit under the inner bearing race, so the pinion must be removed to change them. A puller or press makes that step safer for the bearing and the race. Plan the removal so the bearings stay with their correct races, and clean the carrier seats before reassembly.
Preload comes from the crush sleeve, so tighten the nut gradually and check the turning torque as you go. Set the depth first, then the preload, and finish by checking the gear pattern under light load. Gear oil choice and a clean fill also matter for long-term quiet running. Inspect the carrier again after the first few drives.
- Use a puller or press for pinion removal
- Check turning torque while tightening the nut
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 25-2022 |
| UPC | 631410094947 |
| Kit type | Minor kit |
| Axle location | Rear |
| Axle type | GM 10 Bolt 8.6 Inches |
| Axle manufacturer | GM |
| Manufacturer part number | G/225-2022 |
Vehicle fitment
It is the rear version for GM 10 bolt 8.6 inch axles from 1999 and later. Before ordering, match the axle type and year to this kit. The master version with bearings is 35-2022.
Confirm your vehicle’s axle type and year before ordering.
Installation notes
On this axle the pinion shims sit under the inner bearing race, so pulling it requires a puller or press. Reassemble, set preload with the crush sleeve and read the pattern.
Before starting the 25-2022 job on the GM 10 Bolt 8.6 Inches axle, gather a dial indicator, a torque wrench and clean gear oil. Note the old pattern on the teeth, because the shims in the 25-2022 are the means of correcting the new one. The old nut and seal are replaced. Keep races paired with bearings.
What’s included
- Proper shim kit
- Pinion nut
- Crush sleeve
- Pinion seal
- Ring gear bolts
- Silicone sealer
- Loctite thread locker
- Gear marking compound
Not included: bearings and gears; the 25-2022 is a minor kit for the GM 10 Bolt 8.6 Inches axle.








