Overview
The G2 Ford 9.75 Inch 1999 Earlier Master Ring and Pinion Installation Kit, part number 35-2012, is a master installation kit for rear Ford 9.75-inch axles. The title covers 1999 and earlier, but no vehicle model is named.
G2 says master kits supply the hard-to-find parts a ring and pinion install often needs, including a shim kit, replacement pinion nut, crush sleeve, pinion seal, pinion bearings, carrier bearings, ring gear bolts, silicone sealer, Loctite and gear marking compound. G2 notes these are items general auto parts stores often lack.
Key features
- Shim kit included
- Replacement pinion nut and crush sleeve
- Pinion seal and pinion bearings
- Carrier bearings included
- Ring gear bolts, Loctite and silicone sealer
- Gear marking compound for tooth pattern checks
Pre-install housing checks
Before a master kit goes in, the rear housing needs to be inspected for cracks, bent tubes and worn carrier bores. A housing that has been run hard can shift slightly, which changes pinion depth and carrier preload. Measuring the ring gear diameter and the pinion offset gives you a reference for the setup.
Gear marking compound is most useful once the carrier is set, since it shows the tooth contact pattern under load. Keep old parts until the new setup is checked, so you can compare the wear. Clean all mating surfaces and use new gaskets for the cover.
- Check the housing for cracks and bent tubes
- Confirm the carrier bore is round and clean
- Discard the old crush sleeve after use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2012 |
| UPC | 631410095562 |
| Axle location | Rear |
| Axle type | Ford 9.75 inches |
| Popular axle manufacturer | Ford |
| Kit type | Master kit with bearings |
Vehicle fitment
It is made for rear Ford 9.75-inch axles, 1999 and earlier. Match the rear housing to your axle before ordering.
Confirm your vehicle’s year, model and trim before ordering. Match the 9.75-inch housing before installing.
Installation notes
Setting pinion depth, carrier preload and backlash is the core of this work, and the tooth contact pattern is checked with gear marking compound. Professional gear setup is the usual approach.
What’s included
Shim kit, replacement pinion nut, crush sleeve, pinion seal, pinion bearings, carrier bearings, ring gear bolts, silicone sealer, Loctite and gear marking compound.
Not included: ring and pinion gear set.













