Overview
The G2 Axle and Gear 35-2034 is a master ring and pinion installation kit for the Dana 60 front and rear axle.
The 35-2034 gives a Dana 60 installer one box for the gear rebuild. Contents are a pinion nut and seal, Timken inner and outer pinion bearings with races, pinion shims, carrier shims, carrier bearings with races, ring gear bolts, and the sealing and marking compounds.
The Dana 60 is a common choice for heavy off-road builds. This master kit covers front and rear positions and renews the Timken bearings and races at the pinion and carrier. It adds pinion and carrier shims, a nut and seal, and new ring gear bolts, with thread locker, marking compound and silicone sealer for the cover.
Key features
- Master installation kit for the Dana 60 axle (front and rear)
- Includes pinion Nut
- Includes pinion Seal
- Includes Timken Outer Pinion Bearing and Race
- Includes crush Sleeve
- Includes Timken Inner Pinion Bearing and Race
- Includes pinion Shims
- Includes carrier Shims
- Includes carrier Bearings and Races
- Includes ring Gear Bolts
Heavy-duty pinion preload
Dana 60 setup is slower than lighter axles. Pinion depth, shim selection and preload all need to be measured and confirmed before the cover is sealed. Using a dial indicator and a torque wrench helps keep the numbers repeatable. Take time with the shim stack, since small changes shift the contact pattern noticeably.
Heavy-duty gears carry large loads at the pinion, so the bearings and the crush or solid spacer should be replaced together. Reusing old races can cause the new gears to run out of position. Record each shim thickness as you go.
Gear oil and the cover gasket need the same care as the gears. Clean the cover mating surface, use the silicone sealer where the kit calls for it, and refill to the correct level after break-in. Watch for leaks and noise during the first drives.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2034 |
| UPC | 631410095845 |
| Kit type | Master kit with bearings |
| Axle location | Front and rear |
| Axle type | Dana 60 |
| Axle manufacturer | Dana |
Vehicle fitment
The kit is for Dana 60 axles in the front or rear position. Verify that your housing is a Dana 60 before buying, since the kit is matched by axle rather than by vehicle.
Confirm your vehicle’s axle type, spline count and year before ordering.
Installation notes
Dana 60 setup rewards a careful hand: measure pinion depth, choose shims, tighten the pinion nut to the preload you want and confirm the pattern with the compound. Plan for experienced setup and gentle break-in.
Before opening the Dana 60 housing for the 35-2034 job, gather a dial indicator, a torque wrench and clean gear oil. Record the original gear pattern, because the 35-2034 shims are the tool for moving the new pattern toward it. Fit the new nut and seal. Sort shims by thickness.
What’s included
- Pinion Nut
- Pinion Seal
- Timken Outer Pinion Bearing and Race
- Crush Sleeve
- Timken Inner Pinion Bearing and Race
- Pinion Shims
- Carrier Shims
- Carrier Bearings and Races
- Ring Gear Bolts
- Thread Locking Compound
- Gear Marking Compound
- Silicone Sealer
Not included: ring and pinion gears; the 35-2034 supplies installation parts for the Dana 60 axle only.












