Overview
The Crown Automotive J5362001 is a front axle hub flange gasket for 5-bolt hubs only. It fits the 1981–1983 Jeep CJ5, the 1981–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
The gasket fits either the driver or the passenger side of the front axle. It seals the joint between the hub and the axle drive flange so that gear oil stays in and water stays out of the front hub.
Because it is for 5-bolt hubs only, count the bolts on your hub before ordering. A 6-bolt front hub needs a different gasket.
It pairs with the 5-bolt, 27 spline axle drive flange and covers the same CJ5, CJ7 and Scrambler years. Replacing the gasket whenever the flange comes off is common practice, since a used gasket seldom seals well a second time.
Each front hub takes its own gasket, so a full front axle service needs two. It is a direct-fit part.
A flat sealing part like this one is useful protection for the hub, since a worn gasket lets gear oil seep out after the front axle is reassembled.
Key features
- Front axle hub flange gasket
- Fits the driver or passenger side front
- For 5-bolt hubs only
- Fits 1981 to 1983 Jeep CJ5
- Fits 1981 to 1986 Jeep CJ7 and 1981 to 1985 Jeep Scrambler
- Direct-fit replacement part
Gasket prep and sealing
A hub gasket seals the joint between the hub and the axle drive flange, so its job is to keep gear oil inside and water and grit outside. Gasket surfaces must be clean, flat and free of old material before a new gasket goes on. Scraping with a plastic tool avoids gouging the metal, and wiping with a lint-free cloth removes any residue left behind.
Because the gasket is a thin sealing part, a little dirt or a small bend can cause a leak. Set the flange square and tighten the bolts evenly so the gasket compresses uniformly. Check the front hub for seepage after a short drive, and again after a longer trip on rough ground.
- Scrape old gasket material with a plastic tool
- Wipe the surfaces with a lint-free cloth
- Check for seepage after a short drive
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5362001 |
| UPC | 848399064766 |
| Part type | Front axle hub flange gasket |
| Side | Driver or passenger side front |
| Hub style | 5-bolt hubs only |
| Fitment type | Direct fit |
| Category | Axle parts, hub gears and drive flanges |
Vehicle fitment
The J5362001 hub flange gasket fits these vehicles, with the trims shown:
- 1981–1983 Jeep CJ5 (Base, Laredo, Limited, Renegade)
- 1981–1986 Jeep CJ7 (Base, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
Only 1981 and newer CJ5, CJ7 and Scrambler models are covered. Earlier models with 6-bolt hubs are not covered by this gasket. Match your vehicle’s year, model and trim before placing the order.
Installation notes
One gasket serves one front hub, so a complete front axle service needs two. Verify that your hubs have five bolts before ordering.









