Overview
The RCV Axles D2882-SET is a pair of replacement inner hub gears made from 4340 alloy steel. They fit the 1979–1985 Toyota Pickup and the 1984–1985 Toyota 4Runner with solid front axle factory hubs.
The gears are made entirely from 4340 alloy steel for increased torsional strength, as an upgrade over the factory Toyota solid axle hubs. Installation is straightforward.
The gears fit OEM CV joints and RCV Performance upgraded CV joints, so a truck that keeps its stock CV joints can still use them. RCV warrants the gears against breakage with its No Questions Asked Limited Lifetime Warranty.
The Toyota solid front axle hubs these gears replace were used on the Pickup and early 4Runner, and RCV targets owners who want a stronger inner gear than the factory part. A pair covers both front hubs of the truck.
Part number D2882-SET has UPC 685653664115 for the pair.
Key features
- Pair of replacement inner hub gears
- Made from 4340 alloy steel for increased torsional strength
- Works with OEM CV joints
- Works with RCV upgraded CV joints
- Limited lifetime warranty from RCV
- For Toyota Pickup and 4Runner solid axle factory hubs
Hub gears and CV joint wear
Inner hub gears carry torque from the axle into the hub, so they work under constant load every time the truck drives. Wear usually shows up as rounded teeth, chipping or a clicking noise under throttle. Because the gears mesh with the axle assembly, a worn gear can also stress the bearings and seals nearby, which is why a full inspection is worth doing whenever the hub is opened.
Gear replacement is often done alongside CV joint and seal service, since the same hub area is accessed for all three. Clean and inspect the mating surfaces before reassembly, and use fresh gasket material and grease where the procedure calls for it. Check the hub bearing play after the install and before taking the truck off road.
- Look for chipped or rounded gear teeth
- Inspect the hub seals for leaks
- Check hub bearing play after installation
- Replace CV boots if they are cracked
Specifications
| Brand | RCV Axles |
|---|---|
| Part number | D2882-SET |
| UPC | 685653664115 |
| Part type | Replacement inner hub gear |
| Quantity | 1 pair |
| Material | 4340 alloy steel |
| CV joint compatibility | OEM CV joints and RCV upgraded CV joints |
| Warranty | Limited lifetime warranty (RCV) |
| Fitment type | Direct fit |
Vehicle fitment
RCV states fitment for the 1979 to 1985 Toyota Pickup and the 1984 to 1985 Toyota 4Runner. The manufacturer fitment list gives these vehicles:
- 1984–1985 Toyota 4Runner (DLX, SR5)
- 1974–1985 Toyota Pickup (Base, DLX, DLX Turbo, SR5, SR5 Turbo)
The manufacturer list shows the Pickup from 1974, while RCV’s own description starts at 1979, so check your year. These gears are for solid front axle models only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
RCV describes installation as easy and the gears as a fit for the OEM CV joints, so no CV joint change is needed to use them.
What’s included
One pair of replacement inner hub gears.









