Overview
The Crown Automotive J0942903 is an axle drive flange gasket for the Dana 44 rear axle. It fits the 1959-1966 Jeep CJ5 and CJ6, the 1966 CJ5A and CJ6A, the 1959 CJ3 and the Willys CJ-3, CJ-5 and CJ-6.
Two of these gaskets are required per side, with one on each side of the seal. A rear axle that is being fully resealed therefore needs four, which is worth counting before the axle is opened.
The gasket seals the joint between the axle drive flange and the hub, so the rear axle service on a vintage Jeep ends with the joint sealed again when the flange is refitted.
It is made for the Dana 44 rear axle only, and it fits early CJ and Willys models from the 1950s and 1960s.
Key features
- Axle drive flange gasket for the Dana 44 rear axle
- Two required per side
- One gasket goes on each side of the seal
- Fits 1959 to 1966 CJ5 and CJ6
- Also fits CJ5A, CJ6A and Willys CJ models
- Direct-fit replacement part
Sealing a drum flange
The axle drive flange gasket sits at the joint between the drive flange and the hub. Under rear axle service it is removed and replaced, so the joint stays sealed against road dirt and gear oil. A gasket that is hardened, torn or misshapen can leak and let grit reach the bearings.
Plan the work so every gasket is in hand before the axle is opened, and count the full set first. Clean both mating faces thoroughly, check the flange for nicks and fit the gaskets in the orientation the axle requires. Refill with fresh gear oil once the joint is closed and checked for seepage.
- Count the full set before opening the axle
- Clean both mating faces before assembly
- Check the flange for nicks or burrs
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0942903 |
| UPC | 848399055931 |
| Part type | Axle drive flange gasket |
| Axle | Dana 44 rear axle |
| Quantity needed | 2 required per side, 1 on each side of the seal |
| Fitment type | Direct fit |
| Category | Axle parts, hub gears and drive flanges |
Vehicle fitment
It fits these vehicles, with the trims shown:
- 1959 Jeep CJ3 (Base)
- 1959–1966 Jeep CJ5 (Base)
- 1966 Jeep CJ5A (Base)
- 1959–1966 Jeep CJ6 (Base)
- 1966 Jeep CJ6A (Base)
- 1949–1958 Jeep Willys CJ-3
- 1955–1958 Jeep Willys CJ-5
- 1956–1958 Jeep Willys CJ-6
The CJ5 and CJ6 entries run through 1966, and the CJ7 is not covered. The gasket is for the Dana 44 rear axle only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Plan on four gaskets for a complete rear axle service, since two are required on each side. Each side takes one gasket on either side of the seal.









