Overview
The Crown Automotive J0649784 is a front hub gasket for 6-bolt hubs. It fits a long run of early Jeeps, including the 1959–1981 CJ5, the 1959–1975 CJ6, the 1976–1981 CJ7 and the Willys CJ-2, CJ-3, CJ-5 and CJ-6.
A hub gasket seals the joint between the hub or drive flange and the surface it mounts to, which keeps lubricant in and dirt out of the front hub. This gasket is for the front position on a 6-bolt hub.
That makes it a straightforward renewal item whenever the front hub on a vintage Jeep is apart for a rebuild or an axle service.
Many of the vehicles on the list are older models, from the Willys CJ-2 through the late CJ7, so the gasket is part of keeping an early Jeep front axle sealed. Matching the 6-bolt hub style is the key check, and the year ranges on the list help confirm the rest.
The Willys entries on the list cover the CJ-2, CJ-3, CJ-5 and CJ-6, which makes this one of the wider-fitting hub gaskets in the Crown range.
Key features
- Hub gasket for 6-bolt hubs
- Front position
- Fits the CJ3, CJ5, CJ6 and CJ7
- Fits the 1981 Scrambler
- Fits Willys CJ-2, CJ-3, CJ-5 and CJ-6
- Direct-fit replacement part
Hub seal care and gasket renewal
A hub gasket keeps lubricant inside the hub and dirt out of the joint where the hub meets its mounting surface. On an old Jeep, the gasket is often reused during a bearing service, which is why it can dry out or split without warning. Clean both faces thoroughly and look for old gasket material that could prevent a flat seal.
Seal condition is easiest to judge when the hub is apart. Look for hardening, cracks, flattened areas or oil traces that suggest a slow leak. Keep the gasket dry during fitting, and avoid sealant that could squeeze into the bearing area. Check that the bearings are in good condition and properly adjusted before refitting. After the first drive, look for seepage around the hub and recheck the wheel bolts.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0649784 |
| UPC | 848399053135 |
| Part type | Hub gasket |
| Hub style | 6-bolt hub |
| Position | Front |
| Fitment type | Direct fit |
| Category | Axle parts, hub gears and drive flanges |
Vehicle fitment
It fits these vehicles, with the trims shown:
- 1959 Jeep CJ3 (Base)
- 1959–1981 Jeep CJ5 (Base, Golden Eagle, Laredo, Renegade)
- 1959–1975 Jeep CJ6 (Base)
- 1976–1981 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Renegade)
- 1981 Jeep Scrambler (Base)
- 1946–1949 Jeep Willys CJ-2
- 1949–1952, 1954–1958 Jeep Willys CJ-3
- 1955–1958 Jeep Willys CJ-5
- 1956–1958 Jeep Willys CJ-6
The CJ entries end in 1981, and the Scrambler is for 1981 only, so 1982 and later CJ5 and CJ7 models are not covered. Compare your vehicle’s year, model and trim with this list before buying.
Installation notes
Check that your front hubs are the 6-bolt style before ordering, since this gasket is listed only for 6-bolt hubs.









