Overview
The Crown Automotive G103905 is a hub/shaft key for the AMC Model 20 rear axle. It fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
A hub/shaft key is a small keyed piece that locks an axle shaft to its hub so the two rotate together and the shaft cannot spin freely inside the hub. The key is a low-cost wear part, yet it is easy to lose or damage when a hub is pulled from the shaft.
The AMC Model 20 is the axle this key is made for, so check that axle first when a CJ or Scrambler rear shaft and hub come apart. It is a direct-fit replacement.
Because the part is so small, it is usually bought alongside other axle rebuild items such as seals and gaskets. Ordering it with the rest of the rebuild parts saves a second teardown if the old key turns out to be worn.
It is a direct-fit part. Match it to the AMC Model 20 and to the CJ5, CJ7 or Scrambler year range before ordering.
Key features
- Hub/shaft key for the AMC Model 20 axle
- Fits 1976 to 1983 CJ5
- Fits 1976 to 1986 CJ7
- Fits 1981 to 1985 Scrambler
- Direct-fit replacement part
Keys, hubs and axle wear
A hub key locks the axle shaft to the hub so the two turn together. Under load, a worn key can allow the shaft to slip inside the hub, which shows up as clicking or a loose feel at the wheel. Because the key is small, the keyway in the shaft and the hub bore often wear alongside it, so all three should be checked.
Pulling a hub from the shaft can damage the key, so a puller and a careful removal help avoid a second job. Clean the keyway and check for rounded edges or chips before fitting a new key. Matching the key to the axle type matters, because the keyway size is set by the axle design.
- Check the keyway in the shaft for rounding or chips
- Inspect the hub bore for wear marks
- Use a puller rather than prying the hub off
- Recheck the hub after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | G103905 |
| UPC | 848399050943 |
| Part type | Hub/shaft key |
| Axle | AMC Model 20 |
| Fitment type | Direct fit |
| Category | Axle parts, hub gears and drive flanges |
Vehicle fitment
It fits these vehicles, with the trims shown:
- 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
The CJ5 runs through 1983, the CJ7 through 1986, and the Scrambler covers 1981 to 1985. Other Jeep models do not fit this key. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The key is made for AMC Model 20 axles, so identify your rear axle before ordering. No other installation detail is given.









