Overview
The Crown Automotive Dana 44 axle shaft seal retainer, part number 68008523AA, is a replacement retainer for the Dana 44 axle on Jeep vehicles. It is stated to be a direct fit for 2- and 4-door models. It sits in the Dana 44 oil seals group, so it is the part to compare when replacing a Dana 44 axle shaft seal retainer.
Key features
- Dana 44 axle shaft seal retainer
- Stated direct fit for 2- and 4-door models
- Replacement part from Crown Automotive, a maker of Jeep replacement parts
Seal retainer basics
The seal retainer sits at the end of the axle tube and holds the axle seal in place against the bearing. When the seal wears, gear oil can work past it and onto the brake assembly, which can lead to brake problems over time. Replacing the retainer is most often done when a seal is leaking or when the axle end is being serviced.
A retainer should sit flat and square against the axle housing so the seal runs true. Clean the mating surface, check for nicks or distortion, and use the gasket or sealant the service procedure calls for. Inspect the axle shaft and bearing while the end is open, since worn bearings can bring a leak back soon after repair.
- Clean the housing flange before fitting
- Check the axle shaft for grooves at the seal surface
- Look for oil on the brake backing plate after a drive
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68008523AA |
| UPC | 848399048070 |
| Part type | Axle shaft seal retainer |
| Axle | Dana 44 |
| Body styles | 2- and 4-door models |
Vehicle fitment
It is designed for the Dana 44 axle. Confirm the year, model and trim of your Jeep before ordering, and compare the retainer’s fit to your existing part.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Compare the item’s contents with your installation plan before you start.
