Overview
The Crown Automotive differential pinion seal, part number 639265, is a closed oil seal for the pinion of Dana 25/27 front axles and Dana 41, 44 and 53 rear axles, standard or Trac-Loc.
The axle type decides fit, since no vehicle year, make, model or trim is named for this seal. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Closed oil seal for the differential pinion
- Dana 25/27 front axle application
- Dana 41, 44 and 53 rear standard or Trac-Loc axle application
- Crown Automotive replacement part
Before you replace the seal
A pinion seal sits where the driveshaft yoke meets the differential housing, and it keeps gear oil in while keeping dirt out. When it leaks, oil can collect on the axle housing and the inside of the tire, and low gear oil can wear the pinion bearings over time.
Plan the job around the yoke. Most pinion seal replacements require removing the pinion nut and yoke, so the driveshaft has to come off. Mark the yoke and pinion position before disassembly so the preload and alignment can be checked on reassembly. Check the pinion bearing for play and roughness while the yoke is off, and replace worn bearings at the same time.
- Inspect the pinion yoke sealing surface for grooves before fitting a new seal
- Replace the pinion nut and crush sleeve if the manual calls for it
- Refill with the correct gear oil after the job and check for leaks on the first drive
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 639265 |
| UPC | 848399001662 |
| Seal type | Closed oil seal |
| Front axle | Dana 25/27 |
| Rear axle | Dana 41, 44 and 53, standard or Trac-Loc |
Vehicle fitment
Applications cover Dana 25/27 front axles and Dana 41, 44 and 53 rear axles in standard or Trac-Loc form. Dana 30, Dana 35 and Dana 60 axles are not covered by this seal.
Confirm the differential type of your Dana 44 before ordering, since only standard and Trac-Loc forms are covered.
Installation notes
Pinion seals usually require removing the pinion yoke, so plan for a driveline disconnect.
What’s included
The package contains the pinion seal only. Check the package contents against your installation before starting.









