Overview
The Crown Automotive 3171166K is a master ring and pinion installation kit for Dana 35 rear axles, supplied with bearings. Crown Automotive built it to collect the hard-to-find small parts used in a differential rebuild, so those items come in one package.
The kit is a master kit with bearings for the rear position. Dana 35 is the only fitment detail, and no vehicle years or models are shown.
Key features
- Pinion seal, pinion bearings and crush sleeve
- Carrier bearings and a complete shim kit
- Ring gear bolts and cover gasket
- Silicone sealer and Lock Tite included
- Gear marking compound included
Reassembly and sealing
Reassembly on a Dana 35 rear is mostly about clean surfaces and correct sequence. Sealers and threadlocks are useful at joints where leakage or loosening is a risk, but they should be applied sparingly and only where the sequence calls for them. Excess sealer can squeeze into the bearing or gear area and cause trouble later.
Carrier bearings and the pinion bearing should be seated squarely, and the shim pack should be measured rather than guessed. Inspect the cover gasket and the mating surfaces for nicks before closing the housing, since small damage can leak under load. Fresh fluid after setup is a sensible final step.
- Clean all mating surfaces before sealing
- Apply sealer and threadlock only where needed
- Measure the shim pack before final assembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 3171166K |
| UPC | 848399075526 |
| Kit type | Master kit with bearings |
| Axle type | Dana 35 |
| Position | Rear |
Vehicle fitment
Fitment is limited to the Dana 35 axle type in the rear position. Check year, model and trim against your vehicle before ordering.
Match the Dana 35 axle type to your rear housing, then verify year, model and trim against your vehicle before ordering.
Installation notes
The silicone sealer and Lock Tite are used on specific joints during reassembly, so follow the sequence for your axle. Pinion depth and gear backlash are usually set by a gear setup professional.
What’s included
Pinion seal, pinion bearings, crush sleeve, pinion nut, carrier bearings, ring gear bolts, complete shim kit, cover gasket, silicone sealer, Lock Tite and gear marking compound.
Not included: The ring and pinion gear set is not part of the kit, so plan to source it separately.









