Overview
The G2 Axle and Gear 4-XJ-488M is a complete 4.88 ring and pinion kit with minor installation kits for the front Dana 30 and rear Dana 35 axles of 1984–2001 Jeep Cherokee (XJ) models.
XJ owners regearing for bigger tires get front and rear gear sets, plus a matched minor installation kit for each axle, in one package. The front is a Dana 30 reverse 4.88 sized for a 3.73 and up carrier. The rear is a Dana 35 4.88 for a 3.54 and up carrier. The gears are computer heat treated 8620 steel, built to O.E. specs, double shot peened and double lapped.
A reverse-cut Dana 30 front is the front axle design used in XJ Cherokees. A 4.88 ratio needs a carrier of a certain size, so the front needs a 3.73 and up carrier and the rear Dana 35 needs a 3.54 and up carrier. Match those carrier sizes to the axles in your Cherokee before ordering.
Key features
- Front and rear 4.88 ring and pinion sets
- Front Dana 30 reverse, for a 3.73 and up carrier
- Rear Dana 35, for a 3.54 and up carrier
- Matched minor installation kits for both axles
- Computer heat treated 8620 steel
- Limited lifetime warranty
Regearing for larger tires
Regearing to a 4.88 ratio is usually done to offset larger tires, so the engine turns at a lower speed for the same road speed. The trade-off is slower pull-away in the lower gears and higher engine speed on the highway. Consider how the vehicle is driven most, since a daily driver and a trail rig often want different final drive ratios.
Carriers and the differential are the other half of the job. A new ratio needs a carrier that matches the gear set, so the carrier for each axle has to be right before gears are fitted. Check the carrier for wear, inspect the bearings, and replace worn parts while the axle is open, since reopening it later costs more time.
After the work is done, plan a careful break-in. Drive gently through the first stretch of use, check for whine or clunks, and inspect the gear mesh and fluid levels after the first trips. Use the gear oil suited to the axle type, and keep a log of the service so future work is easier to plan.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-XJ-488M |
| UPC | 631410141344 |
| Part type | Ring and pinion gear kit with minor installation kits |
| Gear ratio | 4.88 |
| Front axle | Dana 30 reverse, 3.73 and up carrier |
| Rear axle | Dana 35, 3.54 and up carrier |
| Steel | Computer heat treated 8620 |
| Finishing | Double shot peened, double lapped |
| Warranty | Limited lifetime |
Vehicle fitment
The kit is for the 1984–2001 Jeep Cherokee (XJ), with a Dana 30 front and Dana 35 rear.
XJs with a Dana 44 rear axle need a different kit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A gear swap needs pinion depth and backlash set correctly, so professional setup and a careful break-in are the normal approach. Both axles are changed as a matched pair.
What’s included
- Front 4.88 ring and pinion set
- Rear 4.88 ring and pinion set
- Front and rear matched minor installation kits
Not included: Bearings and other parts beyond the minor kits are not included.




