Overview
The G2 Axle and Gear 4-TJRUB-513M is a 5.13 ratio front and rear Dana 44 ring and pinion set with minor installation kits, made for the Jeep Wrangler TJ and LJ. Per G2, the kit holds the front and rear gear sets and the minor installation kits for both axles.
G2 calls these complete kits the easiest way to buy a set of gears for your Jeep, and says its sets are engineered to hold up to oversized tires and high performance engines.
Key features
- 5.13 ratio gear sets for front and rear
- Dana 44 axles at both ends
- Minor installation kits for both axles
- Labeled for the TJ and LJ Wrangler
- Single part number covers the swap
Break-in and gear oil
New ring and pinion gears need a careful break-in before they carry full load. Short steady drives with varied throttle help the contact pattern settle. Avoid long highway runs at high speed during the first stretch, and avoid towing or heavy loading until the setup has been checked.
Fresh gear oil matters as much as the gears. Use the lubricant type the axle is built for, and fill each differential to the proper level. Look for leaks at the pinion seal and cover gasket after the first few drives, and retighten fasteners as the service manual directs.
- Replace the pinion seal during the swap
- Use a gear oil additive only if the axle requires it
- Inspect the axle cover gasket for weeping
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 4-TJRUB-513M |
| UPC | 631410141252 |
| Product type | Front and rear ring and pinion sets with minor installation kits |
| Gear ratio | 5.13 |
| Axle manufacturer | Dana |
| Axle type | Dana 44 |
| Axle location | Front and rear |
| Kit class | Minor kit |
Vehicle fitment
The TJ and LJ chassis codes mean the 1997–2006 Jeep Wrangler (TJ) and the 2004–2006 Jeep Wrangler Unlimited (LJ), so fitment follows those codes.
The 4-TJRUB-513M does not cover the YJ or JK, or any Jeep with different axles. Confirm your vehicle’s year, model and trim, and your axle sizes, before ordering.
Installation notes
Each axle needs its own pinion depth, preload and backlash setup, which the shims and parts in the minor installation kits are there to support. Because minor kits assume the bearings are reused, inspect them first, and expect professional setup. Both differentials are reassembled with fresh gear oil, and new gears need a careful break-in. The Dana 44 axles at each end are the ones this kit is made for, so check your axle housings first, and remember that gears at both ends must be changed together to keep the ratio matched.
What’s included
- Front ring and pinion gear set
- Rear ring and pinion gear set
- Minor installation kit for the front axle
- Minor installation kit for the rear axle
Not included: bearings, which this minor kit does not supply.








