Overview
The Alloy USA 11802 is a heavy-duty ball joint kit for the Dana 30 standard front axle. It has a low-profile grease zerk fitting and a high strength steel socket in place of the factory plastic nylon insert.
The ball and shaft are made of SAE 4140 chromoly steel. The ball and socket are assembled with a threaded preload system. The kit is intended for lifted vehicles running larger-than-stock tires.
Alloy USA’s details say the threaded preload system is what holds the ball and socket to precise tolerances, which supports joint life and steering precision.
Key features
- Low-profile grease zerk fitting for regular maintenance
- High strength steel socket replaces the factory plastic nylon insert
- Ball and shaft of SAE 4140 chromoly steel
- Threaded preload system for precise tolerances
- Lubeable
- Steel insert greatly increases ball joint strength and durability
Before you buy
Ball joints carry the weight of the front end and pivot with every steering input, so wear usually shows up as looseness, clunking over bumps or uneven tire wear. When a vehicle runs larger tires than stock, the joints work harder and the steering geometry changes, which is why many owners replace the joints together with the tie rod ends and related steering parts.
Before buying, confirm that the axle matches the kit and compare the old joints against the new ones before starting. Replacing both sides at the same time keeps handling even, and a fresh alignment is needed after any joint change. Keep the grease zerk clean so it can accept fresh lubricant during regular service. Torque every fastener to the vehicle’s service specification.
- Inspect the boot for cracks or tears
- Check for play with the wheel off the ground
- Replace both sides together where possible
Specifications
| Brand | Alloy USA |
|---|---|
| Part number | 11802 |
| UPC | 804314241414 |
| Position | Front |
| Axle type | Dana 30 standard |
| Kit type | Ball joint kit |
| Lubeable | Yes |
Vehicle fitment
It fits the Dana 30 standard front axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that your front axle is a Dana 30 standard before fitting, and use a service manual for your vehicle’s installation steps.
What’s included
A heavy-duty ball joint kit for the front axle.








