Overview
The Dana Spicer 708047 is a ball joint kit for front Dana 60 axles. Confirm your year, model and axle type before installing.
These joints are made to replace the factory units and are designed for 100,000 miles plus in many applications. The kit is not lubeable.
Key features
- Ball joint kit for front Dana 60 axles
- Dodge Dana 60 applications
- Not lubeable
- Part number 708047 from Dana Spicer
Kit fitment and installation
A ball joint kit for a Dana 60 front axle replaces the joints that carry the wheel at the knuckle. Worn joints often show up as a clunk on uneven roads, a shimmy at speed, or steering that wanders when the wheel is released. Checking for play and torn boots during routine service helps catch wear before the tire starts to cup. The joints work under constant load, so small amounts of play tend to grow.
Because the kit is not lubeable, maintenance is limited to inspection. Look for boot tears, check the joints for free movement, and listen for knocks during low-speed turns. Install the new kit with the knuckle properly supported and the stud tapers clean. Expect an alignment after the work, since changing joints can shift the front wheel geometry. Review the axle type and year before ordering to avoid mismatched parts.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 708047 |
| Axle location | Front |
| Axle type | Dana 60 |
| Product type | Ball joint kit |
| Lubeable | Is not lubeable |
| Fitment label | Universal fit |
Vehicle fitment
The Dodge Dana 60 reference names an axle rather than a model. Confirm your year, model and axle type before installing, and do not rely on the universal fit label alone.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plan on a full front-end alignment check after installing a Dana 60 ball joint kit.
What’s included
Sold as one ball joint kit, with the joints supplied together in the kit.









