Overview
The Moog K6509 is a press-in front lower ball joint for the 1996–2000 Chevrolet Tahoe, the 2000 Chevrolet Suburban 1500 and 2500, and the 1999–2000 Cadillac Escalade. Each vehicle carries its own year range, and the Tahoe and Suburban both include the 2000 model year. Check the trim against the vehicle fitment section before ordering.
The joint is greasable and has a hardened ball stud, a powdered metal bearing and a cover plate design with tighter tolerances.
A powdered metal gusher bearing channels grease toward the stud, which reduces friction and supports stud strength. The cover plate is patented, and its tighter tolerances are designed to extend the life of the part compared with conventional cover plates.
The Tahoe entries cover the 1996 through 2000 model years in Base, LS, LT, Limited and Z71 versions. The Suburban entries are limited to the 2000 model year, in the 1500 and 2500 configurations for Base, LS and LT versions. The Escalade entry covers the 1999 and 2000 Base versions, so other Escalade trims and years are not included.
Key features
- Press-in type
- Greasable joint with a larger grease reservoir
- Hardened ball stud
- Greasable socket that Moog says resists corrosion and wear
- Powdered metal bearing that carries grease to the stud
- Patent-pending dust boot with encapsulated Belleville washer
Before pressing in the joint
A press-in lower ball joint is pressed into the control arm, so the job depends on a clean bore and a square fit. Remove any corrosion or old sealant from the arm, and check that the bore is round before pressing. A joint pressed in at an angle can bind or fail early, which is why support under the arm matters.
Once the joint is seated, the greasable socket can be serviced through the pre-tapped fitting. Work grease in until fresh lubricant appears at the boot, then wipe off the excess so dirt does not collect. Regular inspection of the boot for splits helps the joint last, and the tie rod ends and upper joint are often inspected in the same session.
- Clean corrosion from the arm bore
- Support the arm so the press loads straight through the joint
- Wipe excess grease from the boot after lubricating
Specifications
| Brand | Moog |
|---|---|
| Part number | K6509 |
| Position | Front lower |
| Installation type | Press-in |
| Lubeable | Yes |
Vehicle fitment
It fits these vehicles:
- 1999–2000 Cadillac Escalade (Base)
- 2000 Chevrolet Suburban 1500 and 2500 (Base, LS and LT)
- 1996–2000 Chevrolet Tahoe (Base, LS, LT, Limited and Z71)
Other Chevrolet and GMC trucks, and Suburbans from 2001 onward, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint is pressed into the arm. The housing has a pre-tapped grease fitting hole, which Moog says makes the fitting easier to install.
What’s included
Lay out the package contents and confirm them before starting the install. Follow the service procedure for your vehicle before removing the old joint.










