Overview
The Ten Factory MG27106 is a rear replacement axle shaft for GM 14 bolt axles measuring 9.5 inches. It is designed to take the place of the original equipment shaft, with 33 splines and a driver or passenger side location.
The shaft is made from High Manganese 1541H steel, a material suited to a deeper and harder heat treatment. It carries a TEN-Year Replacement Warranty.
Key features
- Built to fit as a direct replacement for OE rear axle shafts
- High Manganese 1541H material
- 33 spline count for GM 14 bolt 9.5 inch rear axles
- TEN-Year Replacement Warranty
Preparing for a shaft swap
A rear axle shaft swap goes faster when the work area and tools are ready before the old shaft comes out. Support the vehicle securely, check the axle fluid level, and mark the shaft’s side so it can be compared with the new part. A clean bench and a quick check of the spline count keep the job moving.
Look at the axle bearing and seal while the shaft is out. The bearing retainer should sit square against the housing, and the seal should show no dried leaks around the lip. Oil that has run down the housing usually points to a seal problem. Address that now, because a new shaft will not last if the seal is still leaking into the bearing.
- Support the vehicle on stands before working
- Mark the old shaft’s side and position
- Inspect the bearing retainer and seal
- Clean the housing bore before installing
Specifications
| Brand | Ten Factory |
|---|---|
| Part number | MG27106 |
| UPC | 698231879429 |
| Axle manufacturer | GM |
| Axle location | Rear |
| Axle shaft location | Driver or passenger side |
| Axle type | GM 14 bolt 9.5 inches |
| Axle spline | 33 splines |
| Material | High Manganese 1541H |
| Warranty | TEN-Year Replacement Warranty |
Vehicle fitment
No vehicle is named. The 14 bolt 9.5 inch axle type and 33 spline count decide whether the shaft matches your axle, so match those measurements before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Count the splines on the old shaft and confirm the 14 bolt 9.5 inch axle type before the new shaft is ordered.
What’s included
The package holds one rear axle shaft. Compare its spline count with the old shaft before installing.








