Overview
The G2 Axle and Gear 98-2031-001 is a Dana 30 front chromoly axle kit with 27 splines for 1987-1995 Jeep Wrangler (YJ) with a disconnect eliminator, 1997 and newer Wrangler (TJ) and 1984-2001 Cherokee (XJ).
The axles are forged from 4340 chrome/nickel alloy, also called chromoly, with extra material around the yoke area of the u-joint cap to help prevent distortion that can damage bearings. They are built for off-road driving, oversized tires and high torque from low-geared setups. The 27 spline count must match the differential or carrier it works with.
Key features
- Front axle kit for the Jeep Dana 30
- 27 spline
- Forged from 4340 chrome/nickel alloy (chromoly)
- Extra material around the yoke area of the u-joint cap
- Uses the 5-760X joint
- Fits YJ with disconnect eliminator, TJ and XJ
Gearing and driveline matching
An axle shaft is only one part of the front driveline. Its spline count has to match the differential or carrier, and the joint, yoke and pinion should be checked as a set when the shaft is replaced. Larger tires and lower gearing put more strain on the shafts and joints, so the drivetrain may be stressed sooner than it would be on stock tires.
When upgrading, check the u-joint and the yoke condition at the same time. Worn u-joints can cause vibration and speed up wear on the new shaft. Replacing the axle seals and checking the lubricant level gives the new parts a clean start, and bearings should be checked for play after the first trail trips.
- Confirm the spline count on both ends before ordering
- Replace u-joints when the shaft is replaced
- Check the fluid level after installation
Specifications
The 98-2031-001 is a chromoly front axle kit for the Dana 30 front axle, with 27 splines.
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 98-2031-001 |
| UPC | 631410097429 |
| Part type | Chromoly front axle kit |
| Axle | Dana 30 Reverse front |
| Spline | 27 spline |
| Material | 4340 chrome/nickel alloy (chromoly) |
| U-joint | Uses 5-760X joint |
| Includes differential | None |
| Application stated | 87-96 YJ with disconnect eliminator, 97-Up TJ, 84-01 XJ |
Vehicle fitment
The kit fits 1987-1995 Wrangler (YJ) with a disconnect eliminator, 1997-2006 Wrangler (TJ) and 1984-2001 Cherokee (XJ). The YJ fit applies to Jeeps with a disconnect eliminator.
It fits 87-96 YJ with disconnect eliminator, 97-Up TJ and 84-01 XJ.
Before ordering the 98-2031-001, compare its spline count, side and overall length with the shaft being replaced.
Confirm your vehicle’s year, model and trim before ordering, including whether it is an LJ, JK or JL.
Installation notes
The kit uses the 5-760X joint, and the YJ application is stated only for Jeeps with a disconnect eliminator. The kit does not include a differential.
What’s included
One axle shaft.
Not included: Differential (the kit includes none).








