Overview
This driver-side outer stub axle shaft is for the Dana 44 front axle in the Jeep Wrangler JK. It fits 2007–2012 Wrangler JK models. Its use is limited to 2007–2009 Rubicon models and to non-Rubicon models that run upgraded aftermarket axles.
It is forged from high-grade alloy steel and heat treated. The 32-spline end accepts a 5-7166X U-joint and is machined for full circle clips.
Key features
- Driver-side outer stub shaft
- 32-spline shaft end
- Accepts a 5-7166X U-joint
- Machined to accept full circle clips
- Forged, heat-treated high-grade alloy steel
Stub shaft wear and fit
An outer stub shaft transfers torque from the hub to the front wheel side and sees repeated shock on the trail. Because it connects the hub end to the U-joint, damage at the spline end often shows up as vibration or as a clunk when the drivetrain changes load. Checking the splines and the joint together helps separate a stub shaft problem from a worn joint.
Owners of heavier front tires should look at the stub shaft more often, since the extra load adds stress at the spline end. Confirm the trim and axle setup before assembly, and keep the hub seal and bearing in good shape so the stub runs clean. Fitting the correct retainer for the axle makes the job easier and safer.
- Inspect the spline end for twisting or wear
- Check the hub seal for leaks before reinstalling
- Replace the U-joint if it has play
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2051-001 |
| UPC | 631410097382 |
| Axle type | Dana 44 JK |
| Axle location | Front |
| Shaft position | Driver side, outer stub |
| Spline count | 32 splines |
| U-joint | Accepts 5-7166X |
| Retainer | Machined for full circle clips |
Vehicle fitment
It fits 2007–2012 Jeep Wrangler (JK) models. The use is narrowed to 2007–2009 Rubicon models and to non-Rubicon models with upgraded aftermarket axles, so match your trim and axle setup to that before ordering.
The passenger-side inner for the JK is a separate part number, and Wrangler TJ, LJ and JL models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the U-joint and retainer match your existing front axle before installing, because the shaft takes a 5-7166X U-joint and is machined for full circle clips.
What’s included
One driver-side outer stub axle shaft.








