Overview
The Omix-ADA 16527.06 is an inner axle bushing for the Dana 30 front axle, made for 1993–1995 Jeep Wrangler (YJ) models with axle disconnect and no ABS.
This small part installs at the intermediate shaft of the Dana 30 front axle on disconnect Wranglers without ABS. It is a direct OE replacement built to original specifications, and it carries a limited five year warranty.
A bushing in an axle shaft assembly supports the intermediate shaft where it passes through the housing, so a worn one can allow movement and noise. This bushing fits Dana 30 front axles on disconnect Wranglers that lack ABS and installs at the intermediate shaft. Axle disconnect is an arrangement in which part of the front axle can be decoupled from the drivetrain, so confirm whether your Jeep has that feature before buying. It is built to original specifications, which suits a repair that matches stock rather than a performance upgrade.
Key features
- Inner axle bushing for the Dana 30 front
- Installs at the intermediate shaft
- For disconnect models
- For non-ABS models
- Direct fit
- Built to original specifications by Omix-ADA, for OE-style replacement.
Signs of a worn bushing
Worn bushings in an axle shaft assembly usually show up as play or a knock when the front wheels are moved under load. Because the intermediate shaft turns inside the housing, looseness at the bushing lets the shaft shift, which can wear nearby seals over time. Check for movement by hand with the vehicle safely supported, and look for grease around the housing.
When the bushing is replaced, inspect the intermediate shaft for scoring at the contact area and check the seals close by. Parts that are often serviced in the same job include the seals and disconnect hardware, since both are reached during the teardown. Keep the work clean and use a lubricant suited to the front axle.
- Play at the front wheels that changes with load
- Grease or fluid around the axle housing
- Scoring on the intermediate shaft
- Hardened or leaking seals near the bushing
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16527.06 |
| UPC | 804314033354 |
| Part type | Inner axle bushing |
| Axle | Dana 30 front |
| Install location | Intermediate shaft |
| Application | Disconnect, non-ABS models |
| Fit type | Direct fit |
| Warranty | Limited five year |
Vehicle fitment
It fits the 1993–1995 Jeep Wrangler (YJ).
Earlier YJ years from 1987 to 1992 and the TJ are not covered. Confirm the year, model and trim against your vehicle before ordering.
Installation notes
Verify that the front axle is a disconnect type and that the Jeep has no ABS before choosing this bushing.








