Overview
The G2 Dana 44 Chromalloy inner axle shaft, part 97-2045-001, is a driver side front inner shaft with 30 splines and a 16.62 inch overall length. It is built for 2003–2006 Jeep Dana 44 axles with the Rubicon option.
G2 forges the shaft from high-grade alloy steel and heat treats it to exceed OEM specifications. It is machined for full circle clips and accepts a 5-760 U-joint.
Key features
- Driver side front inner shaft with 30 splines
- 16.62 inch overall length
- Accepts a 5-760 U-joint
- Machined to take full circle clips
- Forged high-grade alloy steel, heat treated to exceed OEM specifications
Inspecting the old inner shaft
Before removing the old shaft, look at the splines on both ends for rounding, pitting or heat discoloration. Worn splines can cause a clunk when shifting into drive or a vibration under load. Check the boot and the seal area for grease leaks, and note how the U-joint and clips are seated so the new shaft goes back the same way.
Inner shafts carry torque from the differential to the wheel hub, so the U-joint, the axle seal and the carrier bearings are often inspected at the same time. Replacing a worn joint along with the shaft avoids a second teardown. Keep the axle tube clean and check that the clips seat fully before reassembly.
- Check spline wear on both ends
- Inspect the U-joint and clips
- Look for grease leaks at the seal
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 97-2045-001 |
| UPC | 631410097368 |
| Axle type | Dana 44 |
| Axle location | Front |
| Shaft location | Driver side, inner |
| Spline count | 30 splines |
| Overall length | 16.62 inches |
| U-joint | 5-760 |
| Clip style | Machined for full circle clips |
| Material | Forged high-grade alloy steel, heat treated |
Vehicle fitment
It fits 2003–2006 Jeep Dana 44 axles with the Rubicon option. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is made for the Rubicon option axle named above. Compare the 16.62 inch length and the 30 spline count with the shaft you are removing before installing.
What’s included
One inner axle shaft.
Not included: U-joint, clips, bearings and seals.







