Overview
The JK CORE 44 high pinion front axle with a 4.88 ratio and ARB Air Locker, part C4JMFL488AP5, fits 2007–2014 Jeep Wrangler (JK) models in two-door and four-door bodies. It pairs the 4.88 ratio with extra caster for lifts of 6 inches and up.
The housing includes 3 degrees of extra axle caster, which lets the pinion angle improve while keeping caster within proper settings. The axle uses a new generation 8.8-inch JK 44 ring and pinion with a larger pinion shaft, along with 1.5-inch 35-spline Chromalloy shafts.
Key features
- High pinion front layout with 3 degrees of extra axle caster
- New generation 8.8-inch JK 44 ring and pinion with a larger pinion shaft
- USA-made 4340 Chromalloy 1.5-inch 35-spline axle shafts
- Heavy-duty Dana Spicer 5-7166X axle u-joints and a factory-style flange pinion yoke
- Massive forged inner C-ends with integrated skid plates
- Heavy-duty 1/4-inch laser cut brackets and 3-inch diameter, 5/16-inch DOM tubes
- Spanner nuts for backlash adjustment and forged bearing caps
- Heat-treated aluminum differential cover with cooling fins
Using extra caster and high gearing
Caster and pinion angle work together on a lifted Jeep. Raising the truck changes the driveline angles, and a high pinion housing with added caster is one way to bring the pinion closer to the right angle. Check the driveshaft angle after the lift and axle are installed, because a small change can cause vibration at highway speed.
A 4.88 ratio gives strong low-speed pulling and lets a truck run larger tires with less strain on the engine. It also means higher engine speed on the road, so the transmission and fuel economy will feel different. Choose the ratio based on how the truck is used, and expect a mix of trail and highway driving.
Gear sets of this type need careful setup. Backlash and tooth contact should be checked by a qualified shop, and the carrier should be broken in gently. Fluid changes after the first trail season help keep the gears and locker in good shape.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4JMFL488AP5 |
| UPC | 631410120455 |
| Position | Front |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.88 |
| Traction device | ARB Air Locker |
| Axle spline | 35 splines |
| Axle shafts | USA-made 4340 Chromalloy, 1.5 inch, 35 spline |
| Axle tubes | 3 inch diameter, 5/16 inch DOM |
| Carrier bearings | Metric Rubicon-style |
| U-joints | Dana Spicer 5-7166X |
| Differential cover | Heat-treated aluminum with cooling fins |
| Wheel bolt pattern | Reuse factory ends |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
Two-door and four-door 2007–2014 Jeep Wrangler (JK) models are covered by this fitment.
For 2015–2018 JK or other Wrangler generations, confirm your year, model and trim before buying.
Installation notes
The 3 degrees of extra caster are built for lift heights of 6 inches and up, so confirm your lift height before fitting. A 4.88 gear set with a locker needs professional setup and break-in on a Dana 44.
What’s included
The complete high pinion front axle assembly with the 4.88 gear set and ARB Air Locker.

















