Overview
The Dana Spicer 10010742 is an Ultimate Dana 44 front axle assembly with a 5.38 gear ratio and a factory electric locker. It fits the 2007-2017 Jeep Wrangler (JK), and it is a direct bolt-in unit that reuses your stock wheel ends and brakes.
Dana Spicer lists on-trail durability upgrades on this axle: 5/16-inch thick axle tubes, redesigned and thicker brackets, Spicer chromoly axle shafts and SPL 1350 u-joints. The housing also carries improved caster and pinion angles that Dana Spicer says are optimized for lifted Jeeps, and the gross axle weight rating is increased.
Key features
- Selectable electronic locking differential (factory electric locker)
- 5/16-inch thick axle tubes and redesigned, thicker brackets
- Spicer chromoly axle shafts
- Spicer Life Series (SPL) 1350 u-joints with triple lip seals and full-circle clips
- Performance differential cover with a Spicer performance gasket
- Caster and pinion angles optimized for lifted Jeeps
- Increased gross axle weight rating
Gearing and setup
A 5.38 ratio changes how the Jeep pulls, how fast the engine turns at highway speed and how much fuel it uses. Tire size shapes that result as much as the gear itself, so the final ratio should be matched to the tires and the driving the Jeep does most. A locker adds traction when one wheel lifts, but it also makes the axle less forgiving during tight turns on pavement.
Gear sets and lockers need a careful setup. Pinion depth, backlash and bearing preload all affect noise and wear, so have the gear set checked before the first drive. Break-in matters too, since the first miles set the contact pattern that the gears will run on for the rest of their life.
- Match the ratio to your tire diameter and typical speed
- Check pinion and backlash setup before the first drive
- Allow for break-in before heavy towing or rock crawling
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10010742 |
| UPC | 23913483746 |
| Position | Front |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 5.38 |
| Traction device | Factory electric locker (selectable electronic locking differential) |
| Axle tube thickness | 5/16 inch |
| Axle shafts | Spicer chromoly |
| U-joints | Spicer Life Series (SPL) 1350 with triple lip seals and full-circle clips |
| Differential cover | Performance cover with Spicer performance gasket |
| Wheel bolt pattern | 5 on 5 inches |
| Wheel ends | Reuse factory |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
It fits two-door and four-door 2007-2017 Jeep Wrangler (JK) models across that generation.
Fit is set for the 2007-2017 Jeep Wrangler JK generation. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Because the axle reuses the factory wheel ends and brakes, the bolt-in job is limited to the axle itself. Dana recommends a military-tested, approved 75W-140 synthetic lube, which is not included. A 5.38 gear set with an electric locker calls for professional setup and break-in, and the axle should be handled with proper lifting equipment.
What’s included
The Ultimate Dana 44 front axle assembly with the 5.38 gear set, electric locker, chromoly axle shafts and performance differential cover.
Not included: 75W-140 synthetic gear lube.












