Overview
The G2 Axle and Gear JK CORE 44 rear axle with a 4.88 ratio and Eaton E-Locker (part C4JSR488EP0) is for 2007 and newer Jeep Wrangler JK models. This version uses an Eaton E-Locker and a 30-spline axle.
The housing takes the owner’s choice of lockers, and it is a direct fit with reuse factory wheel ends and brakes. USA-made Placer Chromalloy axle shafts are fitted, and the axle is built on the Dana 44 JK 8.8-inch gear layout.
Key features
- Eaton E-Locker
- Dana 44 JK 8.8-inch gear layout in a new housing
- 30-spline axle
- USA-made Placer Chromalloy axle shafts
- Reuses factory wheel ends and brakes
Eaton E-Locker basics
An Eaton E-Locker is electronically actuated, so it engages on command rather than by air pressure. The electrical side of the installation needs the same care as the gears, and a loose connector can leave the locker unusable on the trail.
Locker engagement affects steering on pavement, so the locker is best kept open for normal road driving and used when grip runs out. Watch for clicks or pulling in turns, which can signal a fault that needs a closer look.
With a 30-spline axle, match the shafts and hubs before fitting, since mismatched parts can wear quickly under load. Regular gear oil checks and a look at the seals at each service keep the axle working well for longer.
- Check the wiring harness for chafing
- Confirm the engagement light works before trail use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4JSR488EP0 |
| UPC | 631410120783 |
| Position | Rear |
| Housing type | 07-up Jeep JK Dana 44 |
| Gear ratio | 4.88 |
| Traction device | Eaton E-Locker |
| Axle spline | 30 splines |
| Axle shafts | Placer Chromalloy, USA made |
| Wheel ends | Reuse factory |
| Brakes | Reuse factory |
| Fitment | Direct fit |
Vehicle fitment
This rear axle covers 2007 and newer Jeep Wrangler JK models, within the 2007–2018 range.
Before buying, confirm your year, model and trim, particularly if you own a TJ, LJ or JL Wrangler.
Installation notes
An Eaton E-Locker needs a gear set setup and break-in done by a professional shop, as with any Dana 44 locker. The 30-spline axle has to match the hubs and wheels in use.
What’s included
The complete rear axle assembly with the 4.88 gear set and Eaton E-Locker.
















