Overview
The G2 Axle and Gear CORE 44 rear axle assembly, part number C4TSR488AC5, is a Dana 44 rear axle with a 4.88 ratio and an ARB Air Locker. It is built for 1997-2006 Jeep TJ and 2004-2006 Jeep LJ Wranglers.
The housing is built for loads that would bend a stock Dana 30 or Rubicon Dana 44. Its high pinion layout takes stock ring and pinion sets, axle shafts and aftermarket lockers. The brakes are the factory units, reused, so the existing brake system stays in place.
Key features
- Dana 44 high pinion housing layout
- Designed to take stock Dana 44 ring and pinion sets
- Aftermarket lockers can also be fitted.
- 4.88 gear ratio
- ARB Air Locker traction device
- Factory brakes retained
Factory brakes and differential upkeep
Keeping the factory brakes means the existing hub and brake arrangement stays with the axle, so maintenance follows the same schedule as before. Check the brake lines, hoses and parking brake adjustment during the first service after the swap, since the new axle may settle slightly during setup.
The differential is the other part to watch. Fresh gear oil after an axle swap helps the new gears and bearings run smoothly, and the pinion seal and axle seals should be checked for weeping. Stock Dana 44 gear sets benefit from regular inspection, and a shop familiar with ring and pinion work can spot early wear.
- Inspect brake hoses and lines for chafing
- Check parking brake adjustment early
- Change gear oil after the first few drives
- Look for pinion seal leaks at each oil change
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | C4TSR488AC5 |
| UPC | 631410134018 |
| Housing type | 97-06 Jeep TJ Dana 44 |
| Front or rear | Rear |
| Axle spline | 30 splines |
| Gear ratio | 4.88 |
| Traction device | ARB Air Locker |
| Brakes | Reuse factory |
| Wheel bolt pattern | 5 on 4.5 inches |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1997-2006 Jeep TJ and 2004-2006 Jeep LJ Wranglers.
Coverage is limited to 1997-2006 Jeep TJ and 2004-2006 Jeep LJ Wranglers. Make sure your vehicle’s year, model and trim fall inside that range before buying.
Installation notes
Stock Dana 44 ring and pinion sets fit this housing, so a rebuild can reuse familiar gears. A shop with ring and pinion experience needs to set mesh and bearing preload, and a poor setup wears teeth quickly, so verify it before the vehicle is driven.
What’s included
The assembly includes an ARB Air Locker and a 4.88 ratio in a complete rear axle.
Not included: Ring and pinion gears, axle shafts and brake hardware are not included with the housing.













