Overview
The Eaton 19587-010 is a limited slip differential assembly for rear GM 12 Bolt axles measuring 8.875 inches, with 30 axle splines. Its Posi design uses preload springs and carbon fiber clutches to send torque to the wheel that has grip.
A limited slip differential restricts how far the two axle shafts can spin apart, so a rear axle with one wheel on mud or ice still moves the truck. Eaton positions the Posi for streetable performance, and the assembly can be rebuilt when the clutches or springs need service.
Key features
- Posi limited slip design with preload springs
- Carbon fiber clutches
- Rebuildable assembly
- Built for GM 12 Bolt 8.875 inch rear axles
- 30 spline axle shaft fitment
Carrier swap considerations
Swapping a carrier is more than changing one part, because the ring and pinion, bearings and shims all work as a set. Drivers often inspect the axle shafts, seals and bearings while the carrier is out, since that is when access is easiest. A clean housing and fresh gasket help prevent leaks once the truck is back on the road.
The limited slip action depends on the clutches and preload springs being set up correctly. If the unit is rebuilt, check the clutch surfaces and springs for even wear, and confirm the preload before final assembly. Choosing a gear set that matches the ratio you plan to run keeps the carrier working as intended.
- Check axle shaft seals while the housing is open
- Replace worn carrier bearings with the new unit
- Clean the housing before fitting the carrier
- Set preload using the correct gear service steps
Specifications
| Brand | Eaton |
|---|---|
| Part number | 19587-010 |
| UPC | 70000213978 |
| Axle manufacturer | GM |
| Axle type | GM 12 Bolt 8.875 inches |
| Axle location | Rear |
| Axle spline | 30 splines |
| Differential type | Limited slip assembly |
| Clutch material | Carbon fiber |
| Springs | Preload springs |
| Rebuildable | Yes |
Vehicle fitment
Fit depends on a rear GM 12 Bolt 8.875 inch axle with 30 splines. Make sure the year, model and trim suit your truck before buying.
Confirm your vehicle’s year, model and trim before ordering. A 12 bolt of a different size or spline count is a different carrier.
Installation notes
Swapping the carrier means removing the existing differential, then setting ring and pinion backlash and carrier preload. Gear setup is a job for a shop with that experience.
What’s included
This entry covers the limited slip assembly, part number 19587-010.
Not included: Ring gear, pinion, axle shafts and hardware may be needed, so review your installation parts before starting.









