Overview
The Eaton 19821-010 is a rear E-Locker for Dana 35 axles with 27 splines and a 3.54 up ratio designation. Dana 35 is the only axle type it is made for.
Pressing the push button shifts the locker between open and spool, and only 12 volt power is required. No air lines are involved, so the carrier work and the wiring make up the install.
Key features
- Push button shift between open and spool
- 12 volt power, no air lines
- Rear location
- 27 spline axle shaft fitment
Rear axle upgrade planning
A rear locker changes how the axle shares drive between the wheels, so it is worth planning the whole rear end before the install. Axle shafts, bearings and seals carry more load when the locker is engaged, and worn parts are easier to replace while the carrier is out. Brake components on the same axle can also be inspected at this time.
On trail use, a rear locker keeps the vehicle moving when one tire lifts, while on pavement the open setting keeps steering predictable. Drivers who run larger tires should consider the extra load on the rear gears, and check for tire rub at full steering lock. Keeping a service log helps track when the carrier fluid and wiring were last checked.
- Inspect axle shafts and seals
- Check rear brake parts during the job
- Confirm tire clearance at full steering lock
- Record service dates for the carrier and wiring
Specifications
| Brand | Eaton |
|---|---|
| Part number | 19821-010 |
| UPC | 70000477281 |
| Axle manufacturer | Dana |
| Axle location | Rear |
| Axle type | Dana 35 |
| Axle spline | 27 splines |
| Ratio designation | 3.54 up |
| Locker type | E-Locker, push button selectable |
| Power | 12 volt |
Vehicle fitment
Dana 35 is an axle designation rather than a vehicle model. Match the housing, the 27 spline count and the 3.54 up ratio before buying.
Confirm your vehicle’s year, model and trim before ordering. Rear axles with different spline counts are separate parts.
Installation notes
Rear carrier replacement means pulling the existing unit and setting ring and pinion backlash. Have a shop with that experience do the work, and bring the 12 volt wire to the switch before reassembly.
What’s included
This entry is the E-Locker unit, part number 19821-010.
Not included: A switch, harness, ring gear and pinion are separate from this unit.










